otometrics Bio-Logic NavPRO ONE User manual

Bio-logic®NavPRO ONE®
QUICK START GUIDE
ABR screening

Bio-logic®NavPRO ONE®
QUICK START GUIDE
2
Turning On/Off, and charging the device
Start menu
On/off button
on right side
Current time
Note: this screen (test options)
can vary depending on your set up
Battery indicator
Battery status
Select patient
Additional
information
about options
for current
screen
Turn off device
Customize
Power supply
connector

Bio-logic®NavPRO ONE®
QUICK START GUIDE
3
Please note that single ear testing is shown for ABR screening. For binaural testing instructions,
please refer to the ABR diagnostic Quick Start Guide
Auditory brainstem response (abr) screening
Connect the electrode cable to
the white and the probe to the
red connector.
Clean the patient’s skin and place
the electrode pads. Connect the
clips to the corresponding sites.
White: high forehead
Black: cheek
Red: mastoid

Bio-logic®NavPRO ONE®
QUICK START GUIDE
4
Select the appropriate ear tip size and place it on the probe tip. Insert the probe in the ear making
sure that the ear tip fits tightly into the ear canal.
Select QuickABR button
Select the test ear by pressing either
the Right or Left button
A calibration will be performed prior
to measurement.
A green light indicates
successful calibration.
An impedance check
will be performed prior to
measurement. An impedance
below 6 k ohm is recommended
for best test results.
After successful ear probe calibration
and impedance check, the test will
start automatically. If yellow or
red lights are displayed, check to
make sure you are using the correct
probe tip and ear tip size, that the
eartip is inserted correctly, and that
there is no excessive ambient noise.

Bio-logic®NavPRO ONE®
QUICK START GUIDE
5
ABR sreening test screen
ABR sreening test results
Swipe screen up and down to change
display scale
Swipe screen up and down
to change display scale
Impedance monitor
– impedance should be
below 6 kOhm for best results
Overall screening test result
Pause/resume test
Test parameters and conditions
Print results to a label
or to a pdf file
Normative data for selected age:
red – wave III, green – wave V
Response detection bar
Ongoing EEG – value should remain
in the lower third
Test progress
Test other ear
Stop test

©2020 Natus Medical Incorporated. All Rights Reserved. All product names appearing on this document
are trademarks or registered trademarks owned, licensed to, promoted or distributed by Natus Medical
Incorporated, its subsidiaries or affiliates. 7-26-1388-EN Rev01
Healthcare solutions with one thing in mind. You.
natus.com
Natus Medical Incorporated
Bio-logic®NavPRO ONE®
QUICK START GUIDE
Quick Guide Information
Release date: 2016-12-22
Revision: 01
Valid from: Firmware Rev. 2.1, Bio-link PC Software Rev. 2.0
All mentioned items, products, brands and trademarks are registered or owned by the mentioned companies.
All information, illustrations, and specifications provided within this manual are based on the latest product information available
at the time of publication. PATH medical reserves the right to make changes at any time without notice.
Please contact your local Bio-logic distributor for further information.
Errors and omissions excepted.
Copyright Notice
No part of this manual may be reproduced, translated, stored, or transmitted, in any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise, without the prior written consent of PATH medical GmbH.
Copyright © 2016 PATH medical GmbH
Legal manufacturer of the Bio-logic devices:
PATH medical GmbH
Landsberger Straße 65
82110 Germering
Germany
Tel: [phone]
Fax: [phone]
Internet: www.pathme.de