OTS HULK User manual

1- Open clamp collars and install the cable / Cap lines, pull clamp to tubing. Image 2
* Ensure that the clamp is centered over collar to ensure even cable grip.
2- Swing the collars shut, rotate the bolt into the slot on the collar and torque bolts to
30ft/lbs. (Use Impact sockets that meet or exceed ASME B107.110). Gap should
resemble Image 3, do not over tighten as this may cause damage to the cable.
3- Ensure cable and cap lines are installed and tightened with no damage.
4- Ensure cable does not slack between joints to reduce excessive cable exposure to
casing.
5- Installation time is typically less than 15 seconds.
HULK INSTALLATION MANUAL
FOR DELIVERY/PICKUP/REFURBISHMENT, CONTACT YOUR OTS
REPRESENTATIVE @ [email protected]
1- COLLAR - Holds Clamp to Tubing
2- HINGE PIN - HINGE PIN
3- BODY - Protects Cable and Cap Line
4-
WASHER - Stops Bolt from Backing out
5- BARREL - Holds and Tightens Bolts
6- BOLT - 11mm Hex Head
❶
❷
❸
❹
❻
❺

NOTES:
A- If the cable is tight-lined, remove at least 2 joints of clamps and inspect cable.
a. Continue pulling out and removing clamps until no cable armor appears to
have shifted or tightened around the leads.
b. If any armor has shifted, consult the Service company Service company’s
Technician for recommendation for repair or replacement of cable.
B- If Installation takes longer than 30 seconds, Stop the installation and ensure unit is
installing properly and the clamp is fit to perform.
a. If no obvious sign of improper installation or clamp malfunction, remove clamp
and send back to OTS for product review.
IMAGE 3
IMAGE 2
DO YOU HAVE ANY QUESTIONS OR COMMENTS?
CONTACT US @ [email protected].