Ovela WILLIAM OVWILLWBDNA User manual

WILLIAM WOOD BED
DOUBLE/QUEEN/KING
OVWILLWBDNA, OVWILLWBQNA, OVWILLWBKNA, OVWILLWBDWA,
OVWILLWBQWA, OVWILLWBKWA

Hardware
A50mm M6 screw (x16)
B35mm M6 screw (x12)
CDowel (x8)
D
30mm M4 screw (x28)
E
16mm M4 screw (x8)
F
60mm M7 screw (x4)
GBracket (x2)
HAllen key (x1)
COMPONENTS
2
3
3
5
2
1
1
10
4
5
6
9
7
8
6
4
8
7

Step 1: Align one part labelled 3 level with parts labelled 1and 2. Using the Allen key (H),
secure the part labelled 3 to parts labelled 1 and 2 with 50mm M6 screws (A).
Repeat this process with the remaining parts labelled 1,2 and 3. This will create two end
assemblies.
A(x8) H(x1)
ASSEMBLY
Note:
Do not use power tools to assemble this bed as it may damage the components.
3
3
2
A
H
A
1
2
1
x2

Step 2: Align the holes on one bracket (G) with those on one end assembly. Using a Phillips
screwdriver (not supplied), secure 16mm M4 screws (E) through.
Repeat this process with the remaining end assembly.
E(x4) G(x2)
3
G
E
x2

Step 3: Align one each of the parts labelled 4 and 5 with one part labelled 6. Using the Allen
key (H), secure the pieces (4, 5, 6) together with 35mm M6 screws (B).
Repeat this process with the remaining parts labelled 4, 5and 6. This will create two side
assemblies.
B(x12) H(x1)
4
6
5
B
x2

Step 4: Connect the holes on the side assemblies to those on the end assemblies using the
dowels (C).
C(x8)
C
C
C
C

Step 5: Using the Allen key (H), secure each corner of the side and end assemblies with
50mm M6 screws (A).
A(x8) H(x1)
A
A
A
A

Step 6: Align the holes on parts labelled 7 with parts 8 and 9 as shown below. Using the
Allen key (H), secure 60mm M7 screws (F) through. This creates the middle assembly.
F(x4) H(x1)
F
F
F
H
7
7
8
9
8

Step 7: Using a Phillips screwdriver (not supplied), secure the middle assembly to the end
assemblies with 16mm M4 screws (E).
E(x4)
E
E