OverEZ Chicken Coop 676CKRN3 User manual

Rugged Ranch Chicken Run Adapter
Removing the current panel and replacing with the adapter
This Adapter is for all sizes of OverEZ Chicken Coops and Standard & Mini Chicken Coops with a Rugged Ranch
Chicken Run.
You may need a wrench to replace this panel
STEP 1:
STEP 2:
STEP 3:
Remove the four bolts holding the current panel in place,
Then remove the panel.
After the panel has been removed, you can keep it, or throw it away.
If you plan to use it without an OverEZ Chicken Coop or Standard & Mini
Chicken Coop, we recommend you store it some place.
This is only if you attach this run to an OverEZ Chicken Coop and Standard & Mini Chicken Coops
Insert the Rugged Ranch Chicken Run Adapter.
Install with the four bolts used on the original panel
Finished Product.
See Rugged Ranch Chicken Run Instructions for further details.

Rugged Ranch Chicken Run Adapter Instructions
This Adapter is for all sizes of OverEZ Chicken Coops and Standard & Mini Chicken Coops with a Rugged Ranch
Chicken Run.
You will need a drill or socket set to assemble this chicken run
STEP 1:
After the chicken run has been assembled, install the angle iron on the top, bottom and both sides of the insert.
The wide one is for the bottom. Install the angle pieces with the angle towards the chicken coop and the lip out
(Bottom one is installed the same except the Large OverEZ Chicken Coop and the Standard Chicken Coop, this
needs to be flipped with the angle up) Then fasten with 2 self-tapping screws into each panel
STEP 2:
Push the panel against the chicken coop trim leave approximately 1” away from the latch side of the chicken coop
door. (Optional, insert screws through predrilled holes on the angle pieces into the trim. You will need to use an
extension bit to do this)
STEP 3:
(Optional)
This is only if you have the OverEZ Wire Chicken Coop Panels installed around the bottom of the chicken coop.
Remove the very bottom panel from the insert by removing the bolts, this is to allow the chickens to walk
underneath the chicken coop. Tie the excess wire from the OverEZ Wire Chicken Coop Panels to the run.