OXFORD BABY 10588 User manual

ASSEMBLY INSTRUCTIONS
for Full Bed Conversion Kit
HOLLAND 4 IN 1 ACRYLIC CONVERTIBLE CRIB
Model #10588
"RECOMMENDATION: We recommend the use of a Bunkie Board or
box spring under a mattress for this conversion kit.
1 of 4
10-10588-V-01

Thank you for your purchase!
Remove all parts and hardware from the box and lay on a carpeted or scratch -free work surface.
Do not dispose of any contents until assembly is completed.
Familiarize yourself with all exhibits and diagrams to facilitate the assembly of your crib.
TOOLS REQUIRED:
Do not fully tighten all bolts until all parts are in place.
(please add an extra 1/2 revolution to the bolts when using spring washer after tightening)
PARTS ENCLOSED IN CARTON
A. Rail (2 pcs) B. Slat (5 pcs)
HARDWARE
2 of 4
SCREW DRIVER (Not Included)
(D) Screw 1-1/4"(30 mm) (10 pcs)
ALLEN KEY (Included)
(C) Allen Bolt 1"(25 mm) (2 pcs)
(F) Allen key (2 pcs) (length may vary)
(E) Nut 3/4" (20mm) (2 pcs)
10-10588-V-01

STEP 1.1:
Place Headboard in vertical position and then hook rails (A) to Headboard.
STEP 1.2:
Place Footboard in vertical position and then hook rails (A) to Footboard
STEP 1 " ASSEMBLY OF HEADBOARD AND FOOTBOARD"
THIS STEP REQUIRES :
Headboard (1 pc)
Footboard (1 pc)
A. Rail (2 pcs)
3 of 4
10-10588-V-01
STEP 1.1
STEP 1.2
A
A

STEP 2.1:
- After attaching Rails (A) to headboard and footboard, place Slat (B) on the support strip of Rail (A), fasten
both ends of Slat (B) with screw (D).
- Tighten all Screws with Screw Driver (not included).
STEP 2.2:
- Insert Allen bolt 1" (25 mm) (C), through the top hole in the headboard from the inside and connect with
nut 3/4" (20 mm) (E).
- Tighten all bolts and nuts with Allen key (F). Assembly complete. Thanks you!
STEP 2 " ASSEMBLY OF SLATS"
THIS STEP REQUIRES :
B. Slat (5 pcs)
4 of 4
D. Screw 1-1/4"(30 mm) (10 pcs)
SCREW DRIVER (Not Included)
C. Allen Bolt 1"(25 mm) (2 pcs)
F. Allen key (2 pcs)
E. Nut 3/4" (20mm) (2 pcs)
10-10588-V-01
STEP 2.1
STEP 2.2
D
E
C
F
B