OXFORD BABY HOLLAND ISLAND 10596 User manual

ASSEMBLY INSTRUCTIONS
for Guard Rail
HOLLAND ISLAND 3 IN 1 ACRYLIC CRIB
Model #10596
1 of 4
10-10596-V-01

Thank you for your purchase!
Remove all parts and hardware from the box and lay on a carpeted or scratch -free work surface.
Do not dispose of any contents until assembly is completed.
Familiarize yourself with all exhibits and diagrams to facilitate the assembly of your crib.
TOOLS REQUIRED:
ALLEN KEY (Included)
Do not fully tighten all bolts until all parts are in place.
(please add an extra 1/2 revolution to the bolts when using spring washer after tightening)
PARTS ENCLOSED IN CARTON
2 of 4
10-10596-V-01
A. Guardrail (1 pc)
HARDWARE
(B) Allenbolt 1-3/8" (35 mm) (3 pcs) (C) Spring washer (3 pcs)
(D) Allen key (1 pc)
PARTS REQUIRED
Stabilizer bar (1 pc) (INCLUDED IN THE CRIB CARTON)

STEP 1 " MATTRESS SPRING ADJUSTMENT"
THIS STEP REQUIRES:
10-10596-V-01 3 of 4
G. Allenbolt 1" (25 mm) (4 pcs)
W. Flat washer (4 pcs) H. Nut 3/4" (20mm) (4 pcs)
Mattress spring (1 pc)
M. Allen key (2 pcs)
STEP 1:
- Remove the Allen bolt 1"(25 mm) (G), Spring Washer (W) and Nut 3/4"(20 mm)(H) on
the Mattress spring.
- Move Mattress spring to the lowest position as shown in FIG.1.
- Attach the Allen bolt 1"(25 mm)(G), Spring washer (W) and Nut 3/4"(20 mm)(H) on the
lowest hole of Sideboard.
- Final position as shown in FIG.2.
These hardware are included in the CRIB
FIG. 1
STEP 1
FIG. 2
Lowest
position
M
G
WH

STEP 2:
- Insert the Allen bolt (B), Spring washer (C) through through 2 holes in the stabilizer bar and bottom rail of
Guardrail (A) as shown in FIG.3.
- Insert the Allen bolt (B), Spring washer (C) through the hole in the middle of the side rail of Guardrail (A)
as shown FIG.4.
- Tighten all bolts with Allen key (D). Assembly complete. Thanks You!
STEP 2 " ASSEMBLY OF GUARD RAIL"
THIS STEP REQUIRES :
Stabilizer bar (1 pc)
A. Guard rail (1 pc)
B. Allen bolt 1-3/8" (35 mm) (3 pcs) C. Spring washer (3 pcs)
4 of 4
10-10596-V-01
A
D
B
C
D
B
C
D. Allen key (1 pc)
FIG. 3
FIG. 4
STEP 2