Version 1.3 27 November 2023
10. No parts should be replaced by the customer, except for the mains cables or
the fuse, which must be of the same type and rating as that supplied and as
specified in "Fuse Replacement" on page85, and certified in accordance
with your region’s safety regulations.
11. Make sure all cables are located so that they will not be subject to damage,
especially the mains cable.
12. While running an experiment, keep room temperature as stable as possible.
13. Performance of the system may be adversely affected by rapidly changing
environmental conditions or operation outside of the operating conditions
specified in "Technical Specifications" on page94.
14. Ensure that adequate ventilation is provided as specified in "Environmental
Specifications" on page96.
15. This product is designed to be used in an indoor environment. If the customer
chooses to use this outside, then it is their responsibility to provide adequate
protection. Andor assumes no liability for damage or obligation to repair
under warranty relating to use outside of the environmental requirements
specified in "Technical Specifications" on page94.
16. Medical Diagnosis: This equipment has not been designed and
manufactured for the medical diagnosis of patients.
17. Electromagnetic Compatibility: This product was designed for and tested
using the IEC/EN 61326-1 EMC standard for Class B emissions and a Basic
immunity environment. Class B means that it is designed for a domestic or
residential environment, and Basic immunity refers to the fact that it is not
designed for a typical industrial environment.
18. Electromagnetic Compatibility: As required by IEC/EN 61326-1, we must
inform you that electromagnetic emissions in excess of that required by that
EMC standard for the emissions class of this product can in theory occur due
to its connection to other equipment.
19. Electromagnetic Compatibility: This product has been designed and tested
to perform successfully in a normal (basic) electromagnetic environment,
e.g. a typical life science test laboratory, as per the EU EMC Directive. It is not
designed to operate in a harsh electromagnetic environment, e.g. close to
the following equipment: EMI/RFI generators, electrostatic field generators,
3
