OxyGo OxyGoFIT User manual

Getting Started Guide
Plug the DC Power cord
into the cigarette lighter
or auxillary DC power
supply.
Plug the power output cord
into your OxyGo FIT™and
position your OxyGo FIT™
securely inside the car.
Operate your OxyGo FIT™
and use normally.
After you are familiar with operating
your OxyGo FIT™ at home,you are ready
to take your OxyGo FIT™
on the road.
As always,be a careful driver.
DO NOT RUSH OR HURRY to set up
your OxyGo FIT™in the car.
Take your time and follow the steps
outlined to the right.The OxyGo FIT™
can operate either by battery
or the DC Power Cord while in your
car,boat,or RV.
Make sure your OxyGo FIT™is
secure before driving.
PN 1400-2420
7 Simple Steps to Independence.
Car/Boat/RV Usage
CAUTION
YourEquipment Provider:
YourPhysician:
9/2/2016 3:32:05 PM

Now that you have unpacked each box,you have everything you need to
start using your OxyGo FIT™(PN 1400-2000).The set-up of your OxyGo FIT™
is quick and simple.However,before using the OxyGo FIT™,please read the
entire User Manual.
Place your OxyGo FIT™ in
a well ventilated location.
Ensure the particle filter is
in place.
Insert the OxyGo FIT™ battery by
sliding battery into place
until the latch returns to the
upper position.
Connect the AC input plug to
the power supply,connect the
power output plug to the
OxyGo FIT™.
Plug the power supply
AC cord into the nearest
electrical outlet.
Connect the nasal cannula
tubing into the metal
nozzle on your OxyGo FIT™.
Oxygen will only be
delivered while you are
breathing through the nasal
cannula connected to the
device.
Turn on the OxyGo FIT™ by
pressing the on/off button.
Set the flow setting to the flow rate prescribed
by your clinical professional.The flow setting can
be changed by pressing the circular flow setting
buttons that are marked with“+”and“-”symbols.
Position the nasal cannula on your face and breathe
normally through your nose.
1
2
3
4
5
6
7
NOTE: You must operate the OxyGo FIT™on AC Power for approximately 3 hours to fully charge the single battery.