Ozotech Power Prep Phoenix Manual
M43-31254 REV B
Power Prep Phoenix
Oxygen Concentrator
Operation & Maintenance Manual
OZOTECH, Inc. • 1015 South Main Street, Yreka, CA 96097 • Ph. 530.842.4189 • ozotech.com
1.0 Caution 1
3.0 Operating Conditions 2
3.1 Ambient Temperature 2
3.2 Operating Environment 3
3.4 Input Power Requirements 3
3.5 Features 3
4.0 Maintenance 4
4.1 Compressor Intake Filter 4
4.2.1 Unit Output Pressure 4
TABLE OF CONTENTS
1.0 Caution
contact with water.
this product.
1.
3.0 Operating Conditions
3.1 Ambient Temperature
2.
3.2 Operating Environment
Range
Prolonged operation in such a condition will cause the Molecular Sieve to become saturated
3.4 Input Power Requirements
Note:
3.5 Features
3.
4.0 Maintenance
4.1 Compressor Intake Filter
drawn into the compressor.
Note
4.
5.
4.2.1 Unit Output Pressure
6.
40002 Fan All models
39021 Pressure Regulator All models
7.
6.0 Troubleshooting Guide
Symptom Possible Cause Remedy
Unit does not turn on Unit is not connected to power source, or is
connected to improper power source.
Refer to label on side of chassis for voltage/frequency
requirements.
Connect unit to proper power source.
Beads in desiccant indicator have
turned from blue to pink (or
clear)
Unit is not cycling. Refer to Symptom titled “Unit runs but does not cycle”.
Unit runs but does not “cycle”. Cycle timer is not receiving power; wires
have come o of timer.
Connect cycle timer per wiring diagram.
Compressor output has fallen below manu-
facturer’s specication.
Check pressure as described in Section 4.2.1.
There is an internal air leak. Inspect tubing connections, either visually or with the
aid of a leak checking solution specically designed
for use with oxygen.
Compressor requires service. Check pressure as described in Section 4.2.1.
“Unit Output Pressure”, is out of
manufacturer’s specications.
Unit is connected to improper power source Refer to label on side of chassis for voltage/frequency
requirements.
There is an internal air leak. Inspect tubing connections, either visually or with the
aid of a leak checking solution specically designed
for use with oxygen.
Unit does not produce adequate
concentration of oxygen.
Air ow rate is too high. Adjust air ow meter to lower setting.
Unit is running too hot. Refer to Operating Conditions (Section 5.0) and
Compressor Intake Filter (Section 4.1) for
maintenance information.
Compressor requires service. Check pressure as described in Section 4.2.1.
Unit does not produce adequate
concentration of oxygen, even with
air ow rate reduced and compres-
sor output within specication.
Sieve Bed set has been damaged. Refer to Spare/Replacement Parts for replacement
part information.
There is an internal air leak. Inspect tubing connections, either visually or with the
aid of a leak checking solution specically designed
for use with oxygen.
8.
9.
10.
11.
7.0 Installation
Note:
Note:
generator.
12.
7.0 Installation (contd.)
13.
14.
Link
15.
address.
16.
Table of contents
Other Ozotech Oxygen Equipment manuals
