OYPLA Home 3646 User manual

6 Bottle Spirit Dispenser
User Manual
USER MANUAL Model No: 3646

•This product should only be used for its designated purpose.
•Do not carry out alterations or modifications to this product.
•This product is intended for indoor use only.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage to product.
•Make sure all screws and fittings have been removed from the product carton before
disposing of the carton.
•Before using the product, make sure all screws are tightly in place and that everything
is in order, and checked periodically by an adult.
•Do not attempt to exceed the height limit of 35cm (to note, most bottles will be at this
height or below).
•Dispenses 50ml per push. Allow for the dispenser to fill back up before pushing again
to avoid creating a blockage.
•If the product is damaged or has any defects, please contact [email protected]
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 3646

Operating Instructions
Parts List:
Please be aware that you will be referring to this parts list throughout the assembly process.
USER MANUAL Model No: 3646
1. Place the 50ml dispenser into the bottom section of the dispenser frame (as seen in the
picture on the left) then securing it into place with a screw. Ensure that the screw is holding
the 50ml dispenser to the frame as if it is loose this may make any bottles placed onto this
50ml dispenser unstable. Continue to do this with the remaining 50ml dispensers.

2. Hold the completed dispenser up against the desired surface which you want to install it
on. Make sure that the dispenser if flat before installing. Once you have put it in the correct
position, screw through the holes in the dispenser frame. Make sure that the dispenser is
held tightly to the wall to avoid the weight of the bottles moving the dispenser.
USER MANUAL Model No: 3646
Ensure fully assembled and secure before use.
Please retain a copy of all instructions for future consultation.