OYPLA Home Wellington Boot Rack User manual

User Manual
USER MANUAL Model No: 4022
Wellington Boot Rack

This product is not a toy, and is only to be used for its designated purpose.
Never carry out any alterations or modifications to this product.
This product is intended for indoor use only.
Before using the product, make sure all fastenings are tightly in place and that
everything is in order, and checked periodically.
Do not place multiple pairs on one side of the product, disperse weight evenly.
If additional support is needed, place the product up against a wall. Be wary of
dirt and scuff marks appearing due to possible contact with the Wellington boots.
Leaving the product outside exposed to weather, especially direct sun, rain and salt
air, will speed the weathering process. This can be slowed by removing the product
from these conditions, or covering it with a suitable cover.
Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
If the product is damaged or has any defects, please contact cs[email protected]
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 4022

USER MANUAL Model No: 4022
Operating Instructions
Parts List
Wellington boot holder x 1
Stand x 1
Bolt x 4
Lock nut x 2
Assembly Instructions
1. Unscrew the screws pre-attached to the Wellington boot holder. Once done, align the
holes in the Wellington boot holder with the holes in the stand. Ensure that the stand is
on the outside of the Wellington boot holder. Once done, screw one of the bolts into the
stand and the base of the Wellington boot holder (as seen in the image below).
2. Push a bolt through the other hole, ensuring it goes all the way through. Secure this
into place using a lock nut (please see the image below). Make sure the lock nut has
been secured correctly, as to avoid it becoming loose in the immediate future. After this,
repeat these previous steps on the opposite side to complete the Wellington boot rack.

Imported by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 4022