OZ Trampolines Round In-Ground Trampoline Manual

Our new Inground Trampoline Kits are purpose built and designed specically for inground use. The kits
come with everything you need ‐ strong frame, jump mat and springs, vented safety pads and retaining wall.
Inground Round Trampolines Information Sheet

This top of range trampoline kit is specically designed for in-ground use and is easy to install. You will
need reasonably rm ground to use this kit as the frame sits on a ledge in the ground before you dig-out
the inner hole.
Product Description
Purpose Built Frame
The frame is made from thick galvanised
steel. The mat attaches to the top circular
frame whilst the bottom section forms the
base. The retaining wall is attached to the
top and bottom frame sections.
New Armourweave Jump Mat
The fabric tensile strength is 20% greater
than the normal mat and tear strength
is improved by 30%. Improved air ow
through the mat makes this the best
bounce mat ever made.
TDU Vented Safety Pad
The patented TDU Vented Safety Pad
allows proper airow through the pad
eliminating ‘pad slap’ noise and greatly
improves the bounce quality.
Retaining Wall
This tough and durable retaining wall is
made from a 4.5mm thick eco-friendly
recycled polypropylene/polyethelyne
compound. It quickly and easily attaches
to the frame using 5/16th inch (8mm)
hexagonal self-tapping screws.

1. Dig Hole
Mark out a hole that is a few inches wider in diameter than your trampoline. (This is to give you a little extra
room when you place the trampoline in the hole. It’s difcult to be precise with the hole measurement - the
extra few inches will make it easier for you. This space will be back‐lled at the end.)
Dig out 33cm of soil evenly across the entire hole. Then dig an inner hole in the middle that is 2ft or 60cm
less in diameter than the trampoline size in a bowl shape to a depth of 90cm (about 3ft) for 12ft and 14ft
trampolines and 75cm (about 2ft 6 inches) for 8ft and 10ft trampolines. This will leave a ledge onto which
the trampoline frame will sit.
Installation

2. Assemble Frame
Assemble the top and bottom sections
of the trampoline frame, attach mat and
springs and x the retaining wall to the
outside of the frame.
Installation
3. Place Trampoline in Frame
Lift the trampoline into the hole and place
on the ledge ensuring the frame is at the
correct height. Then back-ll in the gap on
the outside of the frame, compact the soil
and re-turf.
4. Attach Pads
Finally attach the TDU vented pads to
the frame & you’re ready to enjoy your
in-ground trampoline!