Ozark Trail W804 User manual

ASSEMBLY INSTRUCTIONS
MODEL NO W804, 10’ x 5’6” 4P Connectent for Canopy
DANGER
DANGER
WARNING
SAFETY WARNING -
DOs AND DO NOTs
EVERYONE WHO USES THIS TENT SHOULD READ THIS MANUAL AND BECOME FAMILIAR WITH ALL
SAFETY WARNINGS AND PRECAUTIONS FOR SAFE USE, ASSEMBLY, CARE, MAINTENANCE,
AND STORAGE. KEEP THIS MANUAL SO YOU CAN REFER TO IT LATER.
CARBON MONOXIDE GAS WILL KILL YOU
Stoves, heaters, grills, lantern, candles, and other fuel-burning devices that burn propane, natural gas, charcoal, kerosene, coal, or other fuels
produce a toxic gas called carbon monoxide. Because carbon monoxide gas is invisible, odorless, and colorless, a dangerous level of carbon
monoxide gas can accumulate in a tent which cannot be detected by sight, smell, or taste. For these reasons:
• DO NOT use matches, lighters, stoves, heaters, grills, lanterns, candles, cooking equipment, or other fuel-burning devices inside or near a tent.
• DO NOT build fires inside or near a tent.
• DO NOT leave campfires unattended.
Your failure to follow this warning will cause death, serious injury, or permanent disability to you or others.
• DO NOT leave children unattended inside a tent or in camp.
• DO NOT allow children to assemble a tent.
• DO NOT allow children to enter or exit a tent except through the door.
• DO NOT allow children to remain in a closed-up tent on hot days.
Your failure to follow this warning will cause death, serious injury, or permanent disability to your children.
PROTECT YOUR CHILDREN
This tent is made with flame resistant fabric which meets CPAI-84 specification. IT IS NOT FIREPROOF. The fabric will burn if left in continuous
contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.
Your failure to follow this warning could cause death, serious injury, or permanent disability to you or others.
FLAMMABILITY WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC
1. Do not pitch tent near open fire.
2. Do not leave campfire unattended.
3. Do not leave children unattended inside a tent.
4. Do not use heating, lighting or cooking equipment with open flames in or near tents.
5. Do not use other than recommended water repellent compounds on your tent.
6. Do not spray the tent with insecticide.
7. Do not store tent on concrete floor.
CAMPING DO’S AND DON’TS
DO NOT...
1. Always extinguish campfire before leaving area.
2. Exercise care when using electricity and lighting in and near tents.
3. Make certain your tent is properly ventilated in all weather conditions. In extreme weather conditions, snow could obstruct airflow and
cause asphyxiation unless cleared frequently.
4. Anchor your tent securely to provide additional security from changing climatic conditions. Snow pegs, skis and/or heavy rocks may
be necessary to supplement tent stakes and guy cords.
5. Take your tent down and store properly after camping.
DO...
DO NOT LEAVE YOUR TENT SET UP IN DIRECT SUNLIGHT LONGER THAN NECESSARY. THE SUN’S ULTRAVIOLET
(UV) LIGHT DEGRADES ALMOST EVERY FABRIC AND MATERIAL. IF LEFT IN SUNLIGHT FOR PROLONGED PERIODS
OF TIME, FABRIC WILL FADE AND WEAKEN. DO NOT STORE TENT ON CONCRETE FLOOR. DO NOT SPRAY THE
TENT WITH INSECTICIDE.
Your tent is water repellent, however, it is not waterproof. During heavy rain, some leakage may occur. Keep
objects from touching the inside of the tent. Such objects may cause leakage at point of contact. If seam leakage
occurs, it can be controlled by applying a seam sealer compound.
EXERCISE CARE WHEN USING ELECTRIC DEVICES IN AND NEAR TENTS.
Although our tents and screen houses are constructed to rigid specifications, periods of wind or rain
soaking the ground may loosen the stakes and cause the uprights to sink into the ground. This will
weaken the rigidity of the overall structure. Water pockets may also form in the roof if the unit is not
assembled taut, possibly causing broken frames and torn fabric.
If you have questions or need to order a part, call 1-800-325-4121 or send an e-mail to [e-mail].
Have your model number or part number ready when you call. DO NOT ORDER BY REFERENCE KEY NUMBER.
Send your request for parts to:
Exxel Outdoors, LLC.
6235 Lookout Road
Boulder, CO 80301
CARE
REPLACEMENT PARTS
MODEL NO W804, 10’ x 5’6” 4P Connectent for Canopy
4
DESCRIPTION PART NO.
QTY
REQ
KEY
NO.
Steel Stake PIN STAKE

ASSEMBLY INSTRUCTIONS
MODEL NO W804, 10’ x 5’6” 4P Connectent for Canopy
IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE
GOING CAMPING TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT.
NOTE: PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE HOW
YOUR FRAME IS ASSEMBLED.
TO PROLONG THE LIFE OF THE TENT FLOOR, SELECT A LEVEL, CLEAN AREA
FOR THE CAMPSITE. TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE
DOOR TO ALLOW AIR TO ENTER THE TENT.
TO IMPROVE THE WEATHER RESISTANCE OF YOUR TENT, IT IS ADVISABLE
TO USE SEAM SEALER TO COAT ALL EXPOSED SEAMS. YOU SHOULD APPLY
ONLY TO THE UNDERSIDE OF THE FLY AND INSIDE SEAMS OF THE TENT.
IF APPLIED TO THE OUTSIDE SEAMS, DISCOLORATION OF YOUR TENT
MAY OCCUR. SEAM SEALER IS AVAILABLE IN THE CAMPING SECTION OF
ANY LOCAL SPORTING GOODS STORE.
STEP 1: Set up your 10’ x 10’ canopy following the directions that came with
the canopy. Make sure it is staked to the ground.
STEP 4: Starting at the peak of the tent attach the clips on the roof of the tent to
the 2 poles that are on the front side of the canopy.
STEP 5: Locate the two “S” hooks on the elastic cords
that are located at the upper eave corners at the back of
the tent. Connect the “S” hooks to the eyelets in the back
upper corners of the canopy.
STEP 7: There are “S” hooks located at the bottom
corners of the tent. These should be connected to the
holes in the bottom of the canopy legs.
STEP 8: Once the tent is attached to the canopy frame, raise the canopy to
its full height.
STEP 9: Stake down the front two corners of the tent as
well as the two intermediate points along the front and
back walls of the tent. Hammer the stakes into the ground
at a 45° angle using a hammer or mallet, making sure to
pull tent floor out even and snug.
The assembled tent should
appear as shown.
STEP 3: Spread the tent out flat under the canopy, floor side down and unzip
the door.
NOTE: To take down tent, follow steps above in the reverse order. Be sure to
leave door and windows unzipped. MAKE SURE TENT IS CLEAN AND DRY
BEFORE STORING. Place stakes into stake bag which is provided. The tent
should be folded into equal parts toward the center of the tent to distribute the
bulk. Start a small tight roll, the width of the carry bag. Roll the tent towards the
door to allow air to escape. Once rolled, tie a string or rope around tent to hold
into place. Place the rolled-up tent into carry bag.
STEP 2: Lower the height of the canopy to the lowest setting to connect the tent
to the frame.
STEP 6: Tie the three fabric ties located at the 2 sides
of the tent and the center back to the center of the canopy
frame.
WARNING: Elastic cords can snap back and hit your eye.
To reduce the risk of injury to you and others:
• Keep your body and face clear.
• Do not over stretch elastic cords.
• Maintain firm grip on hook.
• Pull the hook toward you; if it slips it will spring away from you.
• Make sure hook is fully clipped to canopy before releasing.
• Wear protective eye wear during tent assembly.
Your failure to follow this warning could cause serious injury or
permanent disability.
Top view.