Ozark Trail W785.1 User manual

ASSEMBLY INSTRUCTIONS
MODEL W785.1, 87”x 34” 1P Backpacking Tent w/vestibule
DANGER
DANGER
WARNING
SAFETY WARNING -
DOs AND DO NOTs
EVERYONE WHO USES THIS TENT SHOULD READ THIS MANUAL AND BECOME FAMILIAR WITH ALL
SAFETY WARNINGS AND PRECAUTIONS FOR SAFE USE, ASSEMBLY, CARE, MAINTENANCE,
AND STORAGE. KEEP THIS MANUAL SO YOU CAN REFER TO IT LATER.
CARBON MONOXIDE GAS WILL KILL YOU
Stoves, heaters, grills, lantern, candles, and other fuel-burning devices that burn propane, natural gas, charcoal, kerosene, coal, or other fuels
produce a toxic gas called carbon monoxide. Because carbon monoxide gas is invisible, odorless, and colorless, a dangerous level of carbon
monoxide gas can accumulate in a tent which cannot be detected by sight, smell, or taste. For these reasons:
• DO NOT use matches, lighters, stoves, heaters, grills, lanterns, candles, cooking equipment, or other fuel-burning devices inside or near a tent.
• DO NOT build fires inside or near a tent.
• DO NOT leave campfires unattended.
Your failure to follow this warning will cause death, serious injury, or permanent disability to you or others.
• DO NOT leave children unattended inside a tent or in camp.
• DO NOT allow children to assemble a tent.
• DO NOT allow children to enter or exit a tent except through the door.
• DO NOT allow children to remain in a closed-up tent on hot days.
Your failure to follow this warning will cause death, serious injury, or permanent disability to your children.
PROTECT YOUR CHILDREN
This tent is made with flame resistant fabric which meets CPAI-84 specification. IT IS NOT FIREPROOF. The fabric will burn if left in continuous
contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.
Your failure to follow this warning could cause death, serious injury, or permanent disability to you or others.
FLAMMABILITY WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC
1. Do not pitch tent near open fire.
2. Do not leave campfire unattended.
3. Do not leave children unattended inside a tent.
4. Do not use heating, lighting or cooking equipment with open flames in or near tents.
5. Do not use other than recommended water repellent compounds on your tent.
6. Do not spray the tent with insecticide.
7. Do not store tent on concrete floor.
CAMPING DO’S AND DON’TS
DO NOT...
1. Always extinguish campfire before leaving area.
2. Exercise care when using electricity and lighting in and near tents.
3. Make certain your tent is properly ventilated in all weather conditions. In extreme weather conditions, snow could obstruct airflow and
cause asphyxiation unless cleared frequently.
4. Anchor your tent securely to provide additional security from changing climatic conditions. Snow pegs, skis and/or heavy rocks may
be necessary to supplement tent stakes and guy cords.
5. Take your tent down and store properly after camping.
DO...
DO NOT LEAVE YOUR TENT SET UP IN DIRECT SUNLIGHT LONGER THAN NECESSARY. THE SUN’S ULTRAVIOLET
(UV) LIGHT DEGRADES ALMOST EVERY FABRIC AND MATERIAL. IF LEFT IN SUNLIGHT FOR PROLONGED PERIODS
OF TIME, FABRIC WILL FADE AND WEAKEN. DO NOT STORE TENT ON CONCRETE FLOOR. DO NOT SPRAY THE
TENT WITH INSECTICIDE.
Your tent is water repellent, however, it is not waterproof. During heavy rain, some leakage may occur. Keep
objects from touching the inside of the tent. Such objects may cause leakage at point of contact. If seam leakage
occurs, it can be controlled by applying a seam sealer compound.
EXERCISE CARE WHEN USING ELECTRIC DEVICES IN AND NEAR TENTS.
Although our tents and screen houses are constructed to rigid specifications, periods of wind or rain
soaking the ground may loosen the stakes and cause the uprights to sink into the ground. This will
weaken the rigidity of the overall structure. Water pockets may also form in the roof if the unit is not
assembled taut, possibly causing broken frames and torn fabric.
If you have questions or need to order a part, call 1-800-325-4121 or send an e-mail to [email protected].
Have your model number or part number ready when you call. DO NOT ORDER BY REFERENCE KEY NUMBER.
Send your request for parts to:
Exxel Outdoors, LLC.
6235 Lookout Road
Boulder, CO 80301
CARE
REPLACEMENT PARTS
MODEL W785.1, 87”x 34” 1P Backpacking Tent w/vestibule
W785.1M
W785.1S
W785.1F
A
DESCRIPTION PART NO.
QTY
REQ
KEY
NO.
Main Pole
Complete Set
Replacement Fly
Guy Rope
7inch 6mm Aluminum Stake
A1001
ALU STAKE
2
1
1
4
11
A
A

ASSEMBLY INSTRUCTIONS
MODEL W785.1, 87”x 34” 1P Backpacking Tent w/vestibule
IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE
GOING CAMPING TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT.
NOTE: PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM TO SEE HOW
YOUR FRAME IS ASSEMBLED.
TO PROLONG THE LIFE OF THE TENT FLOOR, SELECT A LEVEL, CLEAN AREA
FOR THE CAMPSITE. TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE
DOORS TO ALLOW AIR TO ENTER THE TENT.
STEP 1: Spread tent out flat, floor side down.
Top View
NOTE: Make sure tent is clean and dry before storing. To take down
tent, follow steps above in the reverse order. Place stakes into stake bag and
poles into pole bag, which are provided. The tent
should be folded into equal
parts toward the center of the tent to distribute the bulk. Fold fly and lay on top
of tent. Start a small tight roll, the width of the carry bag, with the pole bag
placed at one end. Roll the tent tightly allowing air to escape. Once rolled, tie
a string or rope around tent to hold into place. Place tent, frame and stakes into
carry bag.
STEP 3: Insert the pole tips into the grommets at the back
corners of the tent for each pole. From the front corners,
flex the pole and insert the tip into the corresponding
grommets. (Inner grommets will provide a tauter set up)
STEP 2: Extend the frame poles by pulling out each section and placing ends
into the connectors.
STEP 4: Starting at the top of the tent and working downward,
attach all the clips to the poles.
Tent should appear as shown.
STEP 6: Unfold the fly and place it over the tent. Use the
color-coded webbing to align the fly with the inner tent.
STEP 5: Stake down the tent by inserting stakes through the
stake loops at each corner of the tent. Hammer the stakes
into the ground at a 45° angle. Pull the out even and taut.
If it is windy, the tent can be staked down as part of STEP 1.
Assembled tent should appear as shown
STEP 7: Fasten the hook and loop fasteners sewn to the
fly around the tent poles.
STEP 8: Attach the fly to the tent by hooking the
grommets over the bottom of the pole tips.
STEP 9: Stake down the front vestibule and back of the fly by inserting a stake
through the webbing loops. Be sure to pull the vestibules out even and taut.
STEP 10: Guy ropes have been provided for added
stability. Extend each of the guy ropes and make a loop
at the opposite end by using the slider (as shown). Place
the loop over a tent stake and stake to the ground. Adjust
the slider to make guy rope tight.
A
A