2 1-2020
CONTENTS
1.1 Foreword ...............................................................................................................................4
1.2 EU Declaration of Conformity.............................................................................................5
1.3 Intended use of the machine ...................................................................................................6
1.4 Warning signs .........................................................................................................................6
1.5 Nameplates...........................................................................................................................8
1.6 The main dimensions and models of the machine .........................................................9
1.7 Safety instructions................................................................................................................9
1.8 Noise emission and vibration ...........................................................................................10
1.9 Responsibilities of the operator .......................................................................................10
1.10 Operating conditions ......................................................................................................11
1.11 Terms of warranty...........................................................................................................11
1.12Operating instructions for the winch ............................................................................11
2Taking delivery and setting up the machine for operation..........................................12
2.1 Lifting the machine.............................................................................................................12
2.2 The transport set-up and unpacking ...............................................................................12
2.3 Acceptance inspection ......................................................................................................12
2.4 Main parts of the machine, Fig 1 .....................................................................................12
2.5 Bringing the table extension into the work position, Fig. 2 ..........................................13
2.6 Bringing the conveyor into the work position, Figs. 3 and 4........................................13
2.7 Bringing the conveyor into the work position, Fig. 5.....................................................14
2.8 Adjusting the cutting length, Fig. 6 ..................................................................................15
3Operation of the firewood processor powered by different power sources .............15
3.1 Testing the machine ..........................................................................................................15
3.2 Powered by a tractor .........................................................................................................15
3.3 Suitable revolutions range for the PTO shaft ................................................................16
3.4 Disengagement lever for transmission, Fig. 7...............................................................16
3.5 Required measures in an emergency situation.............................................................16
3.6 Starting under cold conditions (machine powered by a tractor) .................................17
3.7 Electric drive, start and emergency stop........................................................................17
3.8 Starting the electric motor using the Y/D starter, Fig. 8...............................................17
3.9 Emergency stopping of an electrically powered machine, Fig. 8.............................18
3.10 The machine is equipped with a system to prevent simultaneous operation in two
modes, Fig. 9 ................................................................................................................................18
3.11 Operation under cold conditions ..................................................................................19
3.12 Electric heater for oil tank..............................................................................................19
4Full-hydraulic control.........................................................................................................20
4.1 Mastering the safety devices............................................................................................20
4.2 Joystick-valve, Fig. 10.......................................................................................................20
4.3 Other hydraulic operating controls, Fig. 11....................................................................20
5Use of the firewood processor, crosscut operation .....................................................23
5.1 Operating the crosscut saw, before the operation........................................................23
5.2 During the operation ..........................................................................................................23
