Palmetto Craft Palmetto Boon Table User manual

QUALITY AMISH-MADE FURNITURE
Palmetto Boon™Table
Assembly Instructions
Complete assembly videos can be found on
palmettocraft.com
Important Note:
Your furniture has been
kiln-dried and ready to
stain, paint or water seal to
help preserve it and Keep it
looking nice longer. (You may
need to tighten all bolts
and nuts periodically due
to the natural expanding/
contracting of wood.) Please
note, exposure of all woods to
outdoor elements can cause
fading, warping, cracking,
shrinking or expansion. The
manufacturer and distributor
of this product cannot be
held responsible for damage
or changes caused by natural
weathering.
Best Tools Needed
For Assembly:
Hardware
Included:
• Drill • Socket • Hammer
Shown as potting benchShown as serving table
• (10) 2 3/4” bolts
• (10) Washers
• (10) 7/16” Nuts
• (13) Square-head screws
• Square-head drill bit
For support, contact [phone], [e-mail], or visit palmettocraft.com
1. Lay table top face-down on level surface. Attach 4 legs by inserting

holes in the top of legs. Add washers and nuts (see gure 1).
Hand tighten.
Pro Tip: Make sure lines marked for middle shelf on all four legs are
facing in before moving to step 2.
4. Attach triangle shelf supports (2) to front of backboard using
pre-drilled holes and (4) square-head screws (see gure 4).

bolts through pre-drilled holes in middle of legs into pre-drilled holes
in middle shelf. Add washers and nuts (see gure 2). Hand tighten.
5. Attach small shelf to triangle shelf support using (4) square-head
screws through the pre-drilled holes in the top of the shelf (see gure 5).

opposite side of backboard attaching backboard to top shelf.
Pro Tip: Decide now how you would like to assemble your Palmetto
Boon Table.
3. Add (4) Square-head screws in pre-drilled holes securing top of
table to top of legs
(see gure 3).

pre-drilled holes in backboard into pre-drilled holes in table.
Add washers and nuts. Hand tighten.
Potting Bench: 6a. Attach backboard upright (see gure 6a)
Serving Table: 6b. Attach backboard upside down (see gure 6b).
8. Wrench tighten all nuts and bolts.

For support, contact [phone], [e-mail], or visit palmettocraft.com
Leave us a review on our website or Google, and tag us on your social channels using
#MyPalmettoCraft
Love your Palmetto Craft Furniture?
Figure 1 Figure 2
Figure 5 Figure 6a
Figure 6b Finished Potting Bench Finished Serving Table
Figure 3
Figure 4