Panasonic KX-T7400 Series Operation and maintenance manual

PSQW1443YA KF0599KM1059
NOTICE
Printed in Japan
Additional Operating Instructions for KX-T7400 Series and Added and
Changed Features for the Operating Instructions for the KX-TD208E
User Manual Addendum for KX-T7400 Series
Configuration P. 4-5
Other changed items P. 53-55
KX-T7431 / KX-T7433 / KX-T7436 do not have a RINGER Volume Selector.
Please change the default value of [207] “Message Waiting Ring Interval Time”
(3.5 Timer Programming) from 10 minutes to 0 minutes.
P. 53-55 Please delete the System Programming [707] “LCR Leading Digit Entry”
(3.10 LCR Programming, 5.4 Default Values).
Added and Changed Features for Operating Instructions
Changed Features — Section 3.1 System Management
Least Cost Routing P. 48 Please delete the third box from the top, “Does the first digit match the leading
digit?”. Please use the following flow chart.
P. 49 Please delete item (3) “LCR Leading Digit Entry”.
P. 50 Please delete [707] “LCR Leading Digit Entry” from the reference of the
Programming addresses.
P. 55 Please delete the following item.
Flow Chart of LCR
Is the dialled number an emer-
gency call number?
Route 1 is
selected.
BTL is
selected.
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
No
Is the dialled number the BTL
access code?
No
Does the area code match the
route selection code of Route 1?
No
No
No
No
Does the area code match the
exceptional code of Route 1?
Yes
Yes
Yes
Yes
Route 2 is
selected.
Does the area code match the
route selection code of Route 2? Does the area code match the exceptional code of Route 2?
Route 3 is
selected.
Does the area code match the
route selection code of Route 3? Does the area code match the exceptional code of Route 3?
Route 4 is
selected.
Does the area code match the
route selection code of Route 4? Does the area code match the exceptional code of Route 4?
BTL is selected.
Removing
and Adding
the dialled
number.
Removing
and Adding
the dialled
number.
Removing
and Adding
the dialled
number.
Removing
and Adding
the dialled
number.
Added
3.10 LCR
Programming [707] LCR Leading Digit Entry Please change the DEFAULT value from “0” into “Not stored”.