Panduit SDLOCK Series User manual

© Panduit Corp. 2018 INSTALLATION INSTRUCTIONS
For Technical Support: www.panduit.com/resources/install_maintain.asp
V00029PV
Page 1 of 2
Swing Handle Lock
for N-Type and S-Type cabinets
Part Number(s) : SDLOCK-XXX
S-Type Single Hinge Door
Lock Swing Handle Replacement
• Remove Cam Screw (use 10mm socket wrench), Cam Stop (note orientation of Cam Stop), and Cam from existing handle
• Remove Door Handle Backing Plate and remove existing door handle (use 10mm socket wrench)
• Install Swing Handle by securing Door Handle Backing Plate to Swing Handle (use 10mm socket wrench)
• Install Cam, Cam Stop, and Cam Screw (use 10mm socket wrench)
• When replacing Cam Stop, ensure that the orientation is the same as when it was removed.
Tool List:
• 10mm Hex Driver
Cam Screw
Cam
Stop
Door Handle
Backing Plate
Cam
Swing
Handle
Swing Handle Lock
Qty: 1
Swing Handle Lock Key
Qty: 2

© Panduit Corp. 2018 INSTALLATION INSTRUCTIONS V00029PV
Page 2 of 2
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
E-mail:
[email protected]
Phone:
866-405-6654
www.panduit.com
N-Type Single Hinge Door; N-Type & S-Type Solid Rear Door
Lock Swing Handle Replacement
• Remove Cam Screw (use 10mm socket wrench) and Cam Stop (note orientation of Cam Stop) from existing handle
• Remove Door Handle Backing Plate and remove existing door handle (use 10mm socket wrench)
• Install Swing Handle by securing Door Handle Backing Plate to Swing Handle with (use 10mm socket wrench)
• Install Cam Stop and Cam Screw (use 10mm socket wrench)
• Note orientation of Cam Stop
• Ensure that square cutout of Door Rod Assembly sits securely on Swing Handle
• Ensure that door rods are behind door rod guides
Note: Door Rod Assembly does not have to be disassembled. Can be manuvered out of way to install lock.
N-Type and S-Type Split Door
Combination Lock Swing Handle Replacement
• Remove Cam Screw (use 10mm socket wrench) and Cam Stop (note orientation of Cam Stop) from existing handle
• Remove Door Handle Backing Plate and remove existing door handle (use 10mm socket wrench)
• Install Swing Handle by securing Door Handle Backing Plate to Swing Handle (use 10mm socket wrench)
• Install Cam Stop and Cam Screw (use 10mm socket wrench)
• Note orientation of Cam Stop
• Ensure that square cutout of Door Rod Assembly sits securely on Lock Swing Handle
Note: Door Rod Assembly does not have to be disassembled. Can be manuvered out of way to install lock.
Cam Screw
Cam
Stop
Door Handle
Backing Plate
Door Rod
Assembly
(see note)
Swing
Handle
Swing
Handle
Cam Screw
Cam
Stop
Door Handle
Backing Plate
Door Rod
Assembly
(see note)
DoorRodsmustt
behind Door Rod Guides