Paradise Datacom Evolution Series User manual

Version 2
Quick Start Guide
Information that you require:
(As a minimum)
1. Modulator & Demodulator carrier frequencies and power.
2. Satellite framing service requirements.
3. Terrestrial data and base-band requirements.
4. Forward Error Correction requirements.
5. Modulation scheme requirements.
6. System clocking topology.
Power up:
Apply power to the Evolution Series modem using the power lead supplied. When
power is applied wait for the modem to complete initialisation. Once complete press [Main ] .
You are presented with the menus:
1: Status 2: Edit 3: View 4: Test
YOU MUST KNOW YOUR SERVICE REQUIREMENTS BEFORE
CONFIGURING THE MODEM FOR OPERATION OVER SATELLITE. THERE
ARE NO DEFAULT MODEM SETTINGS FOR A SATELLITE SERVICE.

Version 2
Configuration:
All changes are done in the Edit menu. Enter the Edit menu by pressing [2] on
the keypad or highlight and press [ENTER]. You are presented with menus:
1: All 2: Tx 3: Rx 4: Unit 5.Memories
Enter the All menu to be taken, step-by-step, through the essential parameters that need
configuring for basic modem operation.
At each step you are presented with either choices, or a request for a value. Make a choice
either by pressing a number or highlight the value using the Arrow Keys and press Enter
to select.
Current Operational Setting
Unavailable Highlight
Enter a New value either by pressing a number sequence or by using the Arrow Keys
highlight each character and nudge the value up or down. Press Enter to accept the New
value.
Current Operational Setting
Highlight
There are two ways to make choices using the Evolution Series
menu system you can either highlight your choice using the Arrow
Keys and press Enter to select or you can press the associated
numeric key on the keypad.
Set-up Completion:
Pressing the Enter Key takes you to the next step in the Edit-All menu. Once
you have completed each step you have successfully set-up the Evolution Series modem.
You are now ready to operate.