Paradyne 7915-A1 E1 SDSL User manual

TM
1
7915-A2-GK41-00 March 1998
Hotwire 7915-A1 E1 SDSL Standalone Termination Unit
Errata
Document Number 7915-A2-GK41-00
March 1998
Errors and exclusions in the Hotwire Model 7915 Standalone E1 SDSL Termination Unit User’s Guide
(Document No. 7915-A2-GB20-20) were detected after printing. Please make note of the following
correction.
The following information should be included on page B-3:
E1 Network 120 Ohm Connection Cable
Pin Assignments
The 120 ohm modular connector that plugs into the rear panel of
G.703-compatible units has the following pin assignments.
Pin Signal
1Tx Ring
2Tx Tip
3 unused
4 Rx Ring
5Rx Tip
6 – 8 unused
NOTE:
Pin 1 is on the left when viewing the jack from its inserted position.

*7915–A2–GK41–00*