Patiova TETE-A-TETE User manual

POLY TETE-A-TETE
ATTACHMENT
ASSEMBLY MANUAL

Parts List
Tete-a-tete
Tools Required For e Job (Included)
5/32” Hex Key
*NOTE: is Hex Key is used to tighten all the
screws used in the assembly process.
Remove the bolt connecting the block and the
arm rest with 5/32 hex key. Remove the bolt on
both chairs. **Be sure chairs are placed on a flat
surface and slightly angled towards each other.
Step:1
Install stainless steel flat bar using the bolts
removed in step 1. This will create a wedge for
the front part of the tete-a-tete to fit into.
Step:2
Stainless Steel Flat Bar
2 Bolts

4
Position narrow part of tete-a-tete between
bottom of armrests and top of flat bar.
Flat bar should be where the arrow is pointing.
Remove bolt that fastens the armrest to the chair
back. This bolt will not be used again. Push tete-
a-tete forward into wedge until bracket on the
tete-a-tete and the hole in the armrest are
properly aligned.
Install bolt provided in kit assembly bag.
Connect the bracket through the arm and into
the chair back. Repeat on the other chair.
Your assembly is now complete! Be sure four
bolts are properly tightened. Do not lift and
move chairs with the tete-a-tete mounted
between them.
Step:4
Step:6
Step:5
Step:3
Patiova.com [e-mail] 6649 N. Moscow Road Parkesburg, PA 19365 610-857-1359

6649 North Moscow Road
Parkesburg, PA 19365
610-857-1359
patiova.com
[e-mail]