Patriot Lighting 356-9134 Parts list manual

Assembly and operation instructions
SOLAR POWERED ENTRANCE LIGHT WITH MOTION SENSOR
READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING YOUR SOLAR LIGHT. SAVE THIS
MANUAL FOR FUTURE REFERENCE.
Models: 356-9134
Precautions (prior to first use) Features
Assembly and operation
1. Choose a location that receives full, direct sunlight a
minimum of six hours a day and away from light sources
such as torch lights and streetlights, which can cause light
to turn off and flicker.
2. Secure the bracket to the wall. (See Figure 1)
a) For Wood Wall:
Attach the bracket to the desired wall location and screw
the drywall screws directly through the set holes of bracket
into the wall.
b) For Concrete Wall:
Attach the bracket to the desired wall location and mark the targets on the wall from the set holes of bracket
for drilling holes. Remove the bracket. Drill the holes and thread the anchors into the holes. Then reattach
the bracket back, and secure it by screwing the drywall screws into the anchors.
3. Ensure that battery is in place.
Note: Remove the insulated paper before using the light.
4. Switch the light to “OFF” using the switch on the rear of the fixture.
The light has three operating functions selectable by the switch:
- OFF: The light does not turn on.
- ON: The light stays on continuously.
- AUTO: The light operates at night, and illuminates for 60 seconds when motion is detected.
Page 1 / 3
1. To maximize battery capacity, the light should
be fully charged by direct sunlight for eight hours
before initial use.
2. Be sure battery is in secure contact with the
correct polarities.
3. Do not place light near light sources, as the
light may not work properly.
4. Under extremely cold temperatures, the battery
may not charge fully. In such cases, the light
may not stay illuminated as long.
1. No wiring required
2. Easy to install
3. Super Bright White LED Bulb (2x0.5W)
4. Rechargeable AA Ni-Mh battery (600mAh 1.2V)
5. Battery recharged by daylight using built-in
solar panel
6. Three different operation modes:
a.) OFF No light
b.) AUTO Use as a motion sensing light
c.) ON Light stays on continously
Drywall Screw
Keyhole
Anchor
Bracket
Key
Lock
Unlock
Fixture
Motion Sensor
Solar Panel
OFF
AUTO
ON
OFF
AUTO
ON
OFF
AUTO
ON
Drywall Screw
Screw
Battery Cover
Bracket
110607
Figure 1
Figure 3
Figure 2

Troubleshooting
How to replace battery
1. Remove the light from the bracket using the supplied key.
2. Remove four screws on the battery cover. (See Figure 2)
3. Open the battery cover and replace the battery. Be sure the battery is Ni-Mh (600 mAh/1.2V) rechargeable.
4. Restore the battery cover back and reinstall the light onto bracket. (See Figure 3)
Battery
Note
This light is supplied with rechargeable battery, which provide up to eight hours of light at night.
The light should only be used with equivalent battery.
Rechargeable battery must be recycled or disposed of properly.
Check that the switch is not turned in “OFF” mode.
Check that the battery is installed correctly. Be sure battery is in secure contact with the correct polarities.
Cover the solar panel to simulate darkness. The LED should light immediately.
Check that the battery have been charged. The rechargeable battery always need a few hours of daylight
to recharge sufficiently.
Ensure the light is not in shade during the daytime.
•
•
•
•
•
•
•
•
If light does not work, please follow these steps:
5. Do not press on the surface of solar panel,as this can cause damage to solar module.
6. For first use, the solar light requires up to 8 hours or longer of full and direct sunlight to fully charge the
battery.
7. After the battery is fully charged, turn the switch to “AUTO”.
8. There are two mounting holes on the rear of the light. Hang the light on the bracket. To secure the light,
use the supplied keys to lock the light in place.
Page 2 / 3
1. For best performance, install light at least 6 feet above the
ground. At such a height, the lantern will provide a detection
distance of up to 25 feet at 68 degrees Fahrenheit. (See Figure 5)
2. The sensor rotates across a detection range of 110 degrees.
(See Figure 5)
3. The sensor will be more sensitive to motion across its detection
path than motion directly towards it. (See Figure 4)
4. To reduce possible nuisances, do not mount the fixture near a
heat source like an air conditioner, vent or furnace exhaust, or
in a direction facing any reflecting object or other light source.
Where you install your
lantern is important:
Be sure the light is
mounted straight on the
wall; otherwise, the
detection distance
may be limited.
110607
12'
6'
110 Degrees
25 Feet
Least SensitiveMost Sensitive
Figure 4
Figure 5

Page 3 / 3 110607
1-YEAR LIMITED WARRANTY:
This Patriot Lighting fixture carries a limited warranty against defects in material or workmanship. If the Patriot Lighting
product fails at any time within one (1) year after the original date of sale due to defects in material or workmanship,
return the product to Menards with the original sales receipt. At its discretion, Patriot Lighting will replace the defective
fixture with the same or similar fixture or issue a refund. This warranty and any implied warranty (including but not limited
to any implied warranty of merchantability or fitness for a particular purpose) does not cover glass globes, light bulbs,
LEDS, batteries, solar panel and other expendable items. This warranty excludes coverage of finish or color against
tarnishing, flaking, and discoloration. If the original purchaser ceases to own the Patriot Lighting product this warranty
and any implied warranty will be void. This warranty does not cover damage caused by misuse or abuse, including but
not limited to improper installation,improper usage, accident, negligence, unauthorized repair, unauthorized modifications,
or unauthorized maintenance of the fixture. This warranty does not include reimbursement for inconvenience, installation,
setup time, returned shipping charges or defects, losses, labor, injuries to personal property.
This warranty gives the consumer specific legal rights, and the consumer may have other rights which vary from state to
state. The seller’s employees are not qualified to advise on the use of the the fixture. Any oral representations made will
not be binding on seller or its employees.
For questions regarding this product, call toll-free at 1-800-887-6326.