Patton electronics 1092 User manual

Model 1092 QuickStartGuide
Please refertothe stepsbelowto perform an initial test on the Model 1092:
1. Turn POWER OFF
2. Set Configuration Switch S1-6 and S1-7 "OFF"
3. Turn ON the POWER. After 3 to 5 seconds turn thepower OFF.
4. Connect thetwo units together using a two wire twisted pair cableconnecting pin 4to 4 and
pin 5 to 5 of the RJ-45 lineconnectors.
5. Set switch S1-1 ON and S1-2 OFF on bothunits for a data rate of (64Kbps).
6. Set one of the two units for INTERNAL clock ( S1-6 and S1-7ON )
7. Set the other unit for RECEIVE RECOVER clock ( S1-6 ON and S1-7 OFF ).
8. Check the front panel Test Mode Switches, they shouldbe in the NORMAL position.
9. Turn ON the POWER to the Model 1092's. After Approximately30 Seconds the NS
(No Signal) LEDs should turn OFF.
10. After the NS LEDs turn off, move a TEST MODE switch on the LOCAL*modemto REMOTE,
the TM(Test Mode) LED will light on both units.
11. Next select the 511E test mode on theLOCAL modem, the ER (ERror) LED on the LOCAL
modemwill nowFLASH.
12. Return the TestMode Switches to the NORMAL position, the TMand ER - LED'son both
unitsshouldnowbe OFF.
13. The units are nowready foruse.
*NOTE:Eitherunitmaybe defined asthe LOCAL orREMOTEunit.LOCALand REMOTE
designationsare used here onlyforclarification
Patton ElectronicsTechnical ServicesDept.
7622 Rickenbacker Drive Gaithersburg, MD 20879
tel: [phone]
email: [e-mail]
web: www.patton.com