PDP AFTERGLOW PL-7602 User manual

AFTERGLOW™ Remote
For Nintendo Wii
For:
PL-7602
Thank you for purchasing the AFTERGLOW™ Remote for Wii®
Contents:
1 AFTERGLOW™ Remote for Wii®
1 AFTERGLOW™ Remote Wrist Strap
1 Manual
Using the AFTERGLOW™ Remote:
1) The AFTERGLOW™ Remote is designed to work with the Nintendo Wii® videogame system.
The AFTERGLOW™ Remote must be synced to the Nintendo Wii console in order to function.
2) First, remove the battery door from the AFTERGLOW™ Remote and insert two (2) AA
batteries into the compartment according to the battery orientation instructions engraved in
the battery compartment.
3) Next, open the small door on the front of your Wii system. While the Wii is powered ON,
press the red “Sync” button within.
4) Now, press the red “Sync” button in the AFTERGLOW™ Remote’s battery compartment. The
place.
5)
light.
6) Replace the battery door on the AFTERGLOW™ Remote.
7) Before play, always wear the AFTERGLOW™ Remote Wrist Strap and ensure that it is tight-
ened securely around your wrist.
Changing AFTERGLOW™ Modes:
1) -
ATOR”, and “OFF.”
2) The green AFTERGLOW™ button in the AFTERGLOW™ Remote’s battery compartment is
used to cycle through these three modes.
3)
1
1
2
234
A
1
1
2
234
1
1
2
234
CAUTION - Use the Wrist Strap - Wii gameplay with the AFTERGLOW™Remote can involverapid
or vigorous motion. Please ensure to use the enclosed wrist strap to prevent losing yourgrip on
the AFTERGLOW™ Remote and causing damage to the remote or surrounding objects.
1
1
2
234
HOME
POWER
A

4) Press the AFTERGLOW™ button once to cycle to ACCELERATOR setting. The AFTERGLOW™
Remote will vibrate twice to signal the change. In ACCELERATOR mode, AFTERGLOW™ lighting
will activate when the AFTERGLOW™ Remote experiences strong acceleration.
5) Press the AFTERGLOW™ button once more. Three vibrations will signal the AFTERGLOW™
Remote is now on the OFF setting. Only the AFTERGLOW™ Remote’s appropriate player indi-
cator light will glow.
6) To return to ON mode, press the AFTERGLOW™ button once more. One vibration will signal
the remote is now in ON mode.
7) Cycle through the three settings as often as you like and enjoy the AFTERGLOW™ in your
favorite mode!
1
1
2
234
HOME
POWER
A
© 2010 Performance Designed Products LLC. All rights reserved. PDP and AFTERGLOW are trademarks of Performance Designed
Products LLC. Wii is a registered trademark of Nintendo of America, Inc. This product is not designed, manufactured, sponsored or
endorsed by Nintendo.
For technical questions please visit
www.pdp.com or call: 1-800-331-3844 USA ONLY
*please keep this information for future reference
1840 East 27th Street
Vernon, CA 90058 USA
CBX II - Suite 321,382-390 Midsummer Blvd.,
Milton Keynes, Buckinghamshire MK9 2RG United Kingdom
Wa ations to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
ncouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connec to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC ID : X5B-PL7602
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
IC: 8814A-PL7602
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe Best conforme à la norme NMB-003 du Canada.