PDQ 85001 User manual

Operating Voltage 12VDC,24VDC,12/24VDC
Voltage Tolerance ±15%
Current Draw 0.25A/12VDC
0.15A/24VDC
Operating Temperature 14 – 110 degrees F
Humidity 0-95%
For PDQ GR1 and GR2 Cylindrical
Locks
Faceplate
Door Stop
Latch Opening
Base
Cable
2 x M4x0.7 Screw(s)
4 x M5x0.8 Screw(s)
2 x 1-1/4 Wood Screw(s)
2 x M4x0.7 Nut(s)
2 x Butt Splice
Connector(s)
2 x Support Bracket(s)
Included Hardware Installation Instructions
1. Verify that the strike is in the proper mode of operation
(Fail Secure/ Fail Safe). Refer to page 3
2. Prepare frame using the appropriate template for your
frame type. Refer to page 2
3. Connect the strike to power source. Refer to page 3
4. Install the strike unit in jamb cutout using the hardware
provided. Refer to page 2
1
85101
REV 0
6/30/11

ANSI Metal Jamb Installations
Aluminum Jamb Installations
2
85101
REV 0
6/30/11
(2) M4x0.7
(4) M5x0.8
(2) M4x0.7 Nut
(2) Support
(4) M5x0.8

Fail Secure
Apply Power to Open
Fail Safe
Apply Power to Lock
Changing Fail-Safe / Fail-Secure
Strike is shipped from factory in fail-secure configuration. If fail-safe configuration is desired, remove
screw from hole #1 as shown in above diagram and loosen screw #2. Slide screw #2 to opposite end of
the slot and tighten. Install screw #1 into hole labeled fail safe.
Wiring Diagram
Black Black
Red Red
Red
Control Device
(e.g. Reader)
Power
Supply
12vDC/24vDC
Single Voltage (12v or 24v)
12vDC
24vDC
Dual Voltage (12v or 24v)
Black
Black Black
Red Red
Red
Black
Connect wires in Parallel for the 12vDC operation.
N.C. Contact or Access Relay for “Fail-safe” setting
N.O. Contact of Access Relay for “Fail-secure” setting
3
85101
REV 0
6/30/11
Connect wires in Series for the 24vDC operation.