peerless-AV KIPC2540-WHL-EUK User manual

1(2019-05-31) #:150-9222-1
ENG

2(2019-05-31) #:150-9222-1
ENG - Do not begin to install product until you have read and understood the instructions and warnings
contained in this user guide. Before installing make sure the supporting surface will support the combined load of
the equipment and hardware. Screws must be tightly secured. Do not overtighten screws or damage can occur
and product may fail. Never exceed the Maximum Load Capacity. Always use an assistant or mechanical lifting
equipment to safely lift and position equipment. This product is intended for indoor use only. Use of this product
outdoors could lead to product failure or personal injury. To reduce the risk of electric shock or re, do not expose
product to water or moisture. Be sure power cord is routed so that it will not be tripped on, stepped on, or pinched
by heavy items. Avoid overloading electrical outlets or extension cords. Always disconnect the power cord from
the power outlet when installing, servicing, or not using the product for an extended period of time. Do not block
ventilation slots or fan exhaust on product. Blocking airow could damage product. Arrange product to allow air to
ow freely around product. Keep product away from direct sunlight or any source of heat. For support please call
800-4-SIGNAGE.
WARNING
Front of mount
ENG
F
Symbols
ENG
WARNING
ENG
#
Skip to step.
ENG
x3
Screws must get at
least three full turns
and t snug.
ENG Do not overtighten screws.
ENG
Tools Needed for Assembly.
ENG
1
2
ENG To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
4
+1/2
3
3/4"
(19mm)
7/16"
(11mm)

3(2019-05-31) #:150-9222-1
Parts List
KIPC2540-WHL-EUK
Part#
KIPC2542-WHL-EUK
Part#
KIPC2543-WHL-EUK
Part#
KIPC2546-WHL-EUK
Part#Description Qty
Akiosk 1 KIPC2540-WHL-EUK KIPC2542-WHL-EUK KIPC2543-WHL-EUK KIPC2546-WHL-EUK
BM6 x 12mm 4520-1128 520-1128 520-1128 520-1128
CM6 x 25mm 4520-1208 520-1208 520-1208 520-1208
DM8 x 12mm 4520-9571 520-9571 520-9571 520-9571
EM8 x 25mm 4520-1031 520-1031 520-1031 520-1031
Fwasher 8 540-9406 540-9406 540-9406 540-9406
Gspacer 8 600-1215 600-1215 600-1215 600-1215
Hplug adapter 1- - - -
Icable tie 6 560-1756 560-1756 560-1756 560-1756
Jkey 2 565-0049A 565-0049A 565-0049A 565-0049A
Kt-wrench 1 560-1718 560-1718 560-1718 560-1718
Parts (Before beginning, make sure you have all parts shown below).
ENG
Parts List
KIPC2547-WHL-EUK
Part#
KIPC2548-WHL-EUK
Part#
KIPC2549-WHL-EUK
Part#
KIPC2550-WHL-EUK
Part#Description Qty
Akiosk 1 KIPC2547-WHL-EUK KIPC2548-WHL-EUK KIPC2549-WHL-EUK KIPC2550-WHL-EUK
BM6 x 12mm 4520-1128 520-1128 520-1128 520-1128
CM6 x 25mm 4520-1208 520-1208 520-1208 520-1208
DM8 x 12mm 4520-9571 520-9571 520-9571 520-9571
EM8 x 25mm 4520-1031 520-1031 520-1031 520-1031
Fwasher 8 540-9406 540-9406 540-9406 540-9406
Gspacer 8 600-1215 600-1215 600-1215 600-1215
Hplug adapter 1- - - -
Icable tie 6 560-1756 560-1756 560-1756 560-1756
Jkey 2 565-0049A 565-0049A 565-0049A 565-0049A
Kt-wrench 1 560-1718 560-1718 560-1718 560-1718
Parts List
KIPC2555-WHL-EUK
Part#Description Qty
Akiosk 1 KIPC2555-WHL-EUK
BM6 x 12mm 4520-1128
CM6 x 25mm 4520-1208
DM8 x 12mm 4520-9571
EM8 x 25mm 4520-1031
Fwasher 8 540-9406
Gspacer 8 600-1215
Hplug adapter 1-
Icable tie 6 560-1756
Jkey 2 565-0049A
Kt-wrench 1 560-1718

4(2019-05-31) #:150-9222-1
A (1)
kiosk
B (4) C (4)
D (4)
M6 x 12 mm
E (4)
M6 x 25 mm
H (1)
M8 x 12 mm
F (8)
M8 x 25 mm
G (8)
spacerwasher
I (6)
J (2)
key
K (1)
t- wrench
cable tieplug adapter

5(2019-05-31) #:150-9222-1
A
1
Remove
ENG

6(2019-05-31) #:150-9222-1
2
Raise feet, and roll kiosk into viewing location.
ENG
3/4"
(19mm)

7(2019-05-31) #:150-9222-1
3
Lower and level feet so kiosk is fully supported
by feet.
ENG
3/4"
(19mm)

8(2019-05-31) #:150-9222-1
4
J (2)
Remove
ENG

9(2019-05-31) #:150-9222-1
5-1
5-2
5-3
5-4
F F
F F
Remove Remove
ENG ENG
Remove Remove
ENG ENG

10 (2019-05-31) #:150-9222-1
6
7/16"
(11mm)
7
7a 7b
Remove
ENG
40" - 48" 49" - 55"