Pentair Pool Products SHURflo 358 User manual

MOUNTING
• Locate the pump in the deepest position in the
bilge. Keep away from high heat source.
• Mount quick disconnect bracket to bulkhead or
stringer with #10 S.S. screws. Do not drive
screws through hull.
• Route smooth I.D. discharge tubing to a thru-hull
fitting well above the water line . Avoid any
sagging or loops in the tubing. Tubing must go
up from the pump to the thru-hull fitting.
911-742-H Page 1 of 2
ELECTRICAL WIRE:
Use 16GA wire for all circuits. If installation is over 20 feet, use 14GA wire. Brown pump wire must be
hooked to positive power for maximum flow. Wire is tinned to prevent corrosion. PANEL SWITCH:
Attach all wires to UL Marine approved duty switch with auto-off-manual, rated at or above 15 amps.
FUSE: Install a fuse per pump label specifications . CONNECTIONS: Wire connections should be made
above the highest possible water level. Seal wire connections to prevent corrosion and electrolysis.
OPERATION
DO NOT RUN PUMP DRY. ALWAYS TEST PUMP AND SWITCH BEFORE LEAVING DOCK.
EXPLODED VIEW
358™SHURflo BILGE PUMP
Installation and Operation Instructions
ADVANCED BILGE PUMP FEATURES
• Anti-Airlock
• Tough Nylon Housing
• Tinned 6’ Wire Assembly
• Water Cooled Motor
• Submersible
• Ignition Protected
• ISO 8846, ABYC, NMMA Type Accepted, CE
Baseplate tabs press
in for easy removal.
Remove all 7 screws for
cleaning if necessary.
* not supplied

SYMPTOM CHECK FOR
No water pumped/
Pump not running Blown fuse. Wire connections. Impeller or float switch plugged with debris.
Reduction in water
flow
Impeller/screen plugged with debris. Pinch/clogged discharge tubing. Discharge tubing sagging
below pump causing air lock. Tubing must go up from pump to thru-hull fitting. Low voltage to pump;
check battery/wire connections.
Low Flow Polarity reversed; check wiring. Use only smooth bore (I.D.) discharge tubing. Is thru-hull fitting I.D.
smaller than pump discharge port?
LIMITED WARRANTY
SHURflo warrants its 358 SHURflo bilge pumps to be free of defects in material and workmanship under normal use for a
period of three (3) years from date of purchase. In absence of proof of purchase, the warranty is three (3) years from the
date of manufacture indicated on the pump housing. Returns are to be shipped prepaid to SHURflo. This warranty is only
a representation of the complete Marine Products Limited Warranty outlined by Service Bulletin
#
1050. Please contact
SHURflo for complete warranty information.
* Specifications given at design voltage 13.6 VDC per ABYC recommendations.
Pump Power leads: 6 ft. [1.8 M] #16 tinned stranded copper wire to minimize corrosion. Positive (+) brown; Ground (–) black.
Temperature limits: 33ºF—140ºF [0ºC—60ºC]. All models rated for continuous duty.
Approvals: Ignition Protected, ISO 8846, ABYC, NMMA Type Accepted, CE.
MANUAL MODE: To turn pump on, turn manual power switch on. If pump does not turn on, turn switch off, check power,
fuses, connections, wires. Retry. If pump does not turn on, check pump motor.
OPERATION
Do not pump oil, diesel fuel, gasoline or other flammable liquids with this pump. This pump does not prevent the discharge of oil
or other chemicals into the water. Please take appropriate measures to prevent discharging oil or other chemicals and safeguard
the environment. Always disconnect power before servicing pump. Always use fuse size specified in specifications. These bilge
pumps are designed to evacuate standing bilge water only. These pumps maynot prevent boat sinkage due to storms, rough
weather, unsafe boating, improper installation procedures or hull damage.
FLOW GPH [LPH] TECHNICAL DATA
Name Voltage Model #: 0 Ft [0 M] 3 Ft [1 M] 6 Ft [2 M] Max Head Ft [M] Max Amps Fuse Outlet Port Dimensions
1500 *12 V 358-000-00 1800 [6813] 1700 [6434] 1600 [6056] 14 [4.27] 8 10 1-1/8" 7 1/4" X 6"
2000 *12 V 358-010-00 2200 [8327] 2000 [7570] 1900 [7191] 18 [5.5] 10 15 1-1/8" 7 1/4" X 6"
1500 24 V 358-100-00 1800 [6813] 1700 [6434] 1600 [6056] 14 [4.27] 4 6 1-1/8" 7 1/4" X 6"
2000 24 V 358-110-00 2200 [8327] 2000 [7570] 1900 [7191] 18 [5.5] 5 8 1-1/8" 7 1/4" X 6"
Favor de referirse a www.shurflo.com para instrucciones de la instalación del producto y su operación, disponible en varios idiomas.
Fare riferimento al sito www.shurflo.com per manuali multilingue di installazione ed utilizzo prodotti.
Mehrsprachige Hinweise zu Installation und Betrieb des Produktes finden Sie unter www.shurflo.com
Please refer to www.shurflo.com for multi-lingual product installation and operating instructions'
Veuillez vous réferer au site www.shurflo.com pour l'installation produit multilingue ainsi que pour le mode d'emploi.
SHURflo reserves the right to update specifications, prices or make substitutions without notice.
SHURflo SHURflo Europe, Middle East, Africa Visit our Website at www.shurflo.com
52748 Park Six Court Pentair Water Belgium bvba
Elkhart Indiana 46514-5427 B-2200 Herentals, Belgium
Toll Free: [phone] Phone: [phone]
Fax: [phone] Fax: [phone]
911-742 Rev-H
© 2008 - 2012 SHURflo, All Rights Reserved Page 2 of 2