Pentair STA-RITE INTELLIFLO3 VSF User manual

This guide provides instructions for installing the IntelliFlo3 VSF or IntelliPro3 VSF
Variable Speed and Flow Pump Touchscreen Controller. Follow the instructions below
to ensure proper installation.
Installing the Touchscreen Controller allows for complete control of pump scheduling
and programming of other pump features directly from the pump drive.
Removing the Blank Cover
1. Press ON/STOP to stop the pump and disconnect all power to the pump at the
circuit breaker.
STORED CHARGE - Wait at least sixty (60) seconds before opening the wiring
compartment.
2. Using a #2 Phillips-head driver,
unfasten the two Wiring Cover Screws
(1). See FIGURE 1.
3. Remove the Wiring Compartment
Cover and place it aside.
4. Using a #2 Phillips-head driver, remove
the four Blank Cover Screws (2). See
FIGURE 1.
5. Remove the Blank Cover from the drive
assembly.
NOTE: Once the Blank Cover is
removed the three Button Light
Guides are no longer captive.
Ensure these are not lost while
installing the Touchscreen
Controller.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION. Always disconnect power
to the pump at the circuit breaker before servicing the pump. Failure to do so
could result in death or serious injury to service people, users or others due to
electric shock.
Read all servicing instructions before working on the pump.
TOUCHSCREEN CONTROLLER INSTALL GUIDE
FOR INTELLIFLO3® VSF AND INTELLIPRO3® VSF PUMPS
FIGURE 1
1
2

1620 HAWKINS AVE., SANFORD, NC 27330 • [phone]
10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • [phone]
WWW.PENTAIR.COM
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and
logos are the property of their respective owners. Because we are continuously improving our products and services, Pentair
reserves the right to change specications without prior notice.
© 2021 Pentair. All rights reserved. This document is subject to change without notice.
*356234*
P/N 356234 REV. A 10/18/21
Installing the Touchscreen Controller
1. Verify the Button Gasket is correctly
installed onto the Touchscreen
Controller (as shown in FIGURE 2A).
If Button Gasket is NOT properly
installed, Align the gasket as shown in
FIGURE 2B.
2. Align and place the Touchscreen
Controller onto the Drive Assembly as
shown in FIGURE 3.
3. Gently push the Touchscreen Controller
down until it is ush with the top of the
Drive Assembly.
4. Using the four provided Touchscreen
Screws (3), secure the Touchscreen
Controller to the Drive Assembly. See
FIGURE 3.
5. Reinstall the Wiring Cover.
6. Close the Touchscreen Cover when not
in use to protect the screen.
7. Refer to your pump’s Installation and
Maintenance Guide (P/N 356231) for
instructions on restarting your ltration
system and using the Touchscreen
Controller.
FIGURE 2
A B
43
FIGURE 3
3