Congratulations on the purchase of your Perrin & Rowe Product. Correctly installed and with sensible care, this
product will give you many years of trouble free service.
The Soap Dispenser Collection
Installation & User Guide
IMPORTANT INFORMATION
If drilling into tiled walls, be careful to avoid the drill slipping and damaging the glazed surface.
Before you proceed... We recommend you engage the services of a registered plumber to install
this product.
In addition to the guide below it is essential that the written information overleaf is carefully read
and understood.
For ease of possible future servicing, we also recommend the soap pump assembly be flushed
clean every 6 to 7 months pumping warm water through it, preventing any future blockage.
CARE & MAINTENANCE
Wipe down after use to avoid water spotting and mineral build up. Due to metals in this product, if left for long
periods some soaps may discolour.
Occasional cleaning with warm soapy water, followed by a polish with a soft cloth is all that is required to keep
the plated finish in good condition.
Do not use proprietary abrasive liquids, powders, or pads to clean the dispenser. Do not use any
products with ammonia bleach or limescale remover. You will damage the plated finish and void your
guarantee.
BEFORE USE
• If further building work is to be carried out in the vicinity, cover the accessory to avoid damaging the finish.
2. Wall Mounted
1. Deck Mounted The diameter of the hole should be Ø30mm/1.1/8". The maximum
thickness of the surface must not exceed 70mm/2.3/4"
Before inserting the Dispenser Top & Shank ensure the Base part
is screwed onto the Shank section and surface area is clean and
dry.
Please note: The Base 'O' Ring Seal is an essential item and must
be fitted as indicated in diagram.
Once the Shank has been placed through the hole ensure the base
seal is immediately above the mounting surface.
Screw the Retaining Nut onto the Shank beneath the mounting
surface - hand tight is sufficient.
BASE
BASE 'O'
RING SEAL
MOUNTING
SURFACE
RETAINING
NUT
702.3/4"/ MM MAX
30O
1.1/8"
Remove security screw if fitted.
Pull dispenser pump head upwards and refill the container.
Push pump head back into position when filled.
Re-fit security screw if required.
•
•
•
•
500ml - Deck mounted
250ml - Wall and Free Standing
DO NOT OVER FILL
The same refill technique can be
used on the free standing and wall
mounted soap dispenser versions.
When positioning the soap
dispenser, note that the
clamping screw is
positioned at the base of
the rosette. Release
wallplate by unscrewing
clamping screw from the
base of the rosette. (See
hole template for correct
screw hole positions) CLAMPING
SCREW
DRIVE
SCREW
CENTRES
WALL
PLATE
ROSETTE
CENTRE
WALL
PLATE
CENTRE
2mm
Note that the centre line of the wallplate for these fittings is 2mm above the centre line of the accessory
rosette.
Before drilling holes, check centre positions using the accessory as a guide, clamping screw holes should
line up with marked positions.
Use No. 6 masonary drill for the supplied wall plugs. Only use supplied wall plugs where suitable.
When used for the first time it may be
necessary for you to prime the pump
with several downward movements.
The soap is dispensed by a single full
movement downwards.
SHANK
4. Service/Refill
5. OPERATION
Use 1.5mm Key supplied
(Retain key to remove pump)
Grub screw is
supplied but is
optional for
security/anti theft.
