Pet Stop Universal Remote TRAINING SYSTEM User manual

© 2009 Perimeter Technologies, Inc. All Rights Reserved. Printed in U.S.A.
www.petstop.com
Your Local Authorized Pet Stop Dealer is:
Phone Number:
00000000 REV A PS.UROM.0909
Owner’s Manual
Universal Remote
TRAINING SYSTEM
Our products are covered by U.S. Patent Numbers: 5,460,124 – 5,682,839 – 6,296,776
Pet Stop, Comfort Contacts, Flash Alert, Safety Stop, Pet Fence Systems, The Best Fence You'll
Never See, TriScann, Zapp Alert, UltraElite Receiver,UltraMax Receiver, The Dog Fence People,
PowerWizard and RoomWizard are registered trademarks of Perimeter Technologies, Inc.
Perimeter Technologies, Inc. • Morgantown, PA 19543

WARNING: No user-serviceable parts inside. Contact manufacturer or authorized personnel for service.
WARNING: Risk of fire or electric shock. Connect only to UL listed Class 2 transformer for supply connection.
CAutIoN: Risk of electric shock. Install transmitter indoors. Do not expose to rain.
ComplIANCe StAtemeNt (pARt 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
WARNING (pARt 15.21)
Changes or modifications not expressly approved by Perimeter Technologies, Inc., could void the user’s authority to
operate the equipment.
FCC INteRFeReNCe StAtemeNt (pARt 15.105(b))
This equipment has been tested and found to comply with the limits of Class B digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and the receiver
• connect the equipment to an outlet or a circuit different from that to which the receiver is connected
• consult the dealer or an experienced radio/TV technician for help.
ImpoRtANt
SyStem pReCAutIoNS
Any tight collar or consistent pressure on the skin can cause a condition known as pressure
necrosis (bed sores) which if left untreated can be severe. To help reduce the likelihood of pressure
necrosis, please do the following: Remove the pet’s training collar every 12 hours. Look for any skin
irritation and discontinue product use until healed. Wash pet’s neck and collar frequently with warm
soap and water. Do not attempt to wash the collar receiver in the washing machine or dish washer.
No training or containment method is full proof and your Universal Remote Training system is not a
substitute for responsible pet ownership and close supervision of your pet.
Never use this product if you believe your pet is a danger to people, other animals or itself. Discon-
tinue use immediately should your pet demonstrate any aggressive reaction to this product and
seek professional training guidance.
Keep your dog safely contained and on a leash during the initial training.
2

Congratulations!
You’ve selected the Universal Remote Training system by Pet Stop®. The Universal
Remote is the fast and easy way to enjoy the freedom and peace of mind that your pet
fencing system provides, even when you are away from home. It’s great for solving
frustrating problem behaviors such as digging, jumping and not coming when called.
How It Works:
The Universal Trainer transmits a brief attention getting pulse, pleasant vibration or au-
dible warning tone to your dog’s fencing collar reminding him that the healthy respect
for his fence at home applies when you two are in the house or away from home too!
For fence trained dogs the tone only option can instantly bring his attention back you
just when you need it most.
The Universal Remote Training System Includes:
For the best results, please read this manual and all accompanying information in its
entirety. If you have any questions, please contact your local Pet Stop dealer.
Introduction
3
Handheld
Remote
Remote
Receiver
2 – 3.6v Lithium
Ion Batteries
(SAFT LS14250 batteries only)

Remote Functions
4
TONE ONLY
Press and hold the TONE button to activate the warning tone for up to 10 seconds. After
ten seconds the button needs to be released and pressed again to reactivate. Most dog
fence trained pets will respond quickly to only the warning tone without need for ad-
ditional stimulation.
VIBRATION
The VIBRATION function is most often used as a “praise button” or positive reinforcement
for positive behaviors. Providing treats or praise while pressing the vibration button will
help reward your dog for desirable behaviors.
½ SECOND STIMULATION
Press and release to provide a brief ½ second of stimulation from the fencing collar
receiver.
1 SECOND STIMULATION
Press and release to provide a longer 1 full second of stimulation from the fencing collar
receiver for difficult or dangerous situations.
NOTE: The Handheld Remote will emit a long beep and flashing red light
should any command from the Handheld and the remote receiver fail. This
condition is most likely caused by the pet being out of range. Move closer
and attempt again. With a direct line of sight, you can expect the effective
range to be 150 feet.
Tone Only
Function
1/2 Second
Stimulation
Power Light Indictor
Dog 1
Indicator Light
Dog 2
Indicator Light
Vibration
Function
One Second
Stimulation
On / Off – Press & hold for 2 seconds
to turn handheld remote OFF

Before First Use
5
STEP ONE
Insert one 3.6v lithium ion battery in the back
of the handheld remote with the (+) terminal
facing to the right of the battery compartment.
Insert the second 3.6v lithium ion battery in
the remote receiver with the (+) terminal fac-
ing towards the battery compartment opening.
Using a small coin, replace the battery cap
turning clockwise.
STEP TWO
• Press and hold the ON/OFF button for
one second; there is a small delay to
power up the handheld remote. The
indicator lights will briefly blink.
• Select DOG 1 (left) or DOG 2 (right)
by pressing and releasing the DOG
TOGGLE button.
• Press and hold the DOG TOGGLE button.
The DOG LIGHT will slowly flash red.
Successful set up will be confirmed
with a flashing green light.
• This setup function only needs to be
performed once. The Universal Remote
will retain the collar’s unique code.
• Press and hold the TONE or VIBRATE
functions to ensure proper operation of
the Remote Receiver unit.

Before First Use
6
STEP THREE
Attach the Remote receiver to the fencing collar nylon strap. The location can be to the
right or left, but within 3 inches of fencing collar receiver for proper stimulation activation.
STEP FOUR
The Universal Remote needs to be programmed to provide stimulation from the systems
pet fence collar. To program the Universal Remote to any brand of pet fence use the fol-
lowing steps:
1. Walk the Handheld Remote unit out
into the yard and stand over or near
the system’s fencing buried wire. Near
the end of the driveway is a likely spot.
2. Press and hold the DOG
TOGGLE BUTTON and the TONE
BUTTON simultaneously
3. Flashing RED lights for two
seconds indicates no containment
field was found – try another
fence boundary location.
4. The Handheld remote will indicate
successful programming with steady
RED lights for two seconds – the
system is now fully operational.

Manual Programing
7
In the event that the Universal Remote cannot automatically detect your particular system
frequency settings, you can manually program the remote following the steps below:
1. Simultaneously press and hold the
DOG TOGGLE button and the TONE
button for three seconds or until the
POWER light is solid red.
2. Release the DOG TOGGLE and
POWER buttons.
3. Press the TONE button the number
of times that corresponds to your
particular fence manufacturer and
frequency setting. The POWER light
will blink off for a short time to
confirm your selection.
4. Press and release the VIBRATION
button. The POWER light will blink
to confirm the number you have
selected.
BRAND FReQueNCy
1Pet Stop 7K
2Pet Stop 10K
3Pet Stop 14K
4Pet Stop 4K
5Dog Guard 7K
6Dog Guard 10K
7Dog Guard 15K
8Invisible Fence 7K
9Invisible Fence 10K
10 Invisible Fence 15K
11 Dog Watch 7K AM
12 Dog Watch 4K AM
13 PetSafe 7K
14 PetSafe 10K
15 PetSafe 15K

poWeR lIGHt
INDICAtoR
DoG lIGHt
INDICAtoRS
oFF Unit turned off or
funtioning normally.
Unit turned off or DOG
not selected.
SolID ReD System successfully
programmed. N/A
SolID GReeN N/A Operation normal.
FlASHING ReD Battery in handheld
remote is low.
Contact is lost or remote
receiver is out of range.
FlASHING GReeN N/A Operation normal.
Battery in collar unit is low.
Indicator Light Chart
8

Notes
9

Notes
10

THIS
PAGE LEFT
INTENTIONALLY
BLANK

© 2009 Perimeter Technologies, Inc. All Rights Reserved. Printed in U.S.A.
www.petstop.com
Your Local Authorized Pet Stop Dealer is:
Phone Number:
00000000 REV A PS.UROM.0909
Owner’s Manual
Universal Remote
TRAINING SYSTEM
Our products are covered by U.S. Patent Numbers: 5,460,124 – 5,682,839 – 6,296,776
Pet Stop, Comfort Contacts, Flash Alert, Safety Stop, Pet Fence Systems, The Best Fence You'll
Never See, TriScann, Zapp Alert, UltraElite Receiver,UltraMax Receiver, The Dog Fence People,
PowerWizard and RoomWizard are registered trademarks of Perimeter Technologies, Inc.
Perimeter Technologies, Inc. • Morgantown, PA 19543
lImIteD lIFetIme WARRANty
Perimeter Technologies®, Inc. warrants that its products to the original retail purchaser will be free
from defects in material and workmanship, under normal use, for a period of one year from the date of
the original retail purchase at no cost. Shipping to repair center not included. This coverage does not
include accidental damage or misuse. After one year from date of original consumer purchase,
Perimeter will, at our option repair, replace or upgrade the defective component at a fixed rate based
on the component, for the life of the original owner. Owner must provide proof of purchase. Cost of
shipping is not covered under the limited lifetime warranty. Some shipping charges may apply.