PEZTIO K11 User manual

USER MANUAL
ANY PROBLEMS, please contact us by Email.
Here is the address:
US Customers: [e-mail]
EU Customers: [e-mail]
DASH CAM
1080P HIGH DEFINITION WIDE ANGLE LENS

INTRODUCTION
Welcome to use PEZTIO DASH CAM. This is Model K11, which
equipped with 1080p lens. Automatic start to record, just plug
and play, video files will be saved on the memory card.
-POWER SOURCE
Use car charger (5V 1A) to get power from cigarette lighter. Need
to keep the power on to ensure the normal use.
-MAIN FUNCTION
1. Loop Record
The Loop recording video can be set the timing 1 min, 3min or 5
min. It will save the vital videos in case losing or damaging the
videos when an accident occurs, the TF card slipped out or the
power connection is loosening.
2. Emergency Record
Motion Detection: When the Motion Detection is on, it will detect
whether there is the moving object, and the recording will auto
on if it finds a moving object.
Gravity Sensor: When there is a severe bump in vehicles, the video
will be locked and will not be deleted by cyclic recording.
-MULTIPLES MODES
There are 3 modes of camera operation - Video, Photo and
Playback.
1. Video Mode: The default mode when the camera is turned on,
for video recording.
2. Photo Mode: Allows you to take still photographs.
3. Replay Mode: Allows you to view recorded video or
photographs upon the DASH CAM IPS screen.
WARNING:
Please keep the DASH CAM plugged into the power, plug and
play it. This is a small capacity battery. It will automatically shut
down after 10 seconds when the disconnect power.

-PACKAGE CONTENT
DASH CAM
SUCTION MOUNT
CAR POWER
CABLE
USER MANUAL
WARRANTY
CARD
PRODUCT SPECIFICATION
Display Screen
3.0-inch IPS Screen
G-sensor
Built-in
Resolution
FHD 1080P/720P/480P
Sensor
170 Degree Ultra-Wide Angel Lens
Language
English, German, Japanese, etc.
File Format
AVI
Video Format
M-JPEG
Picture Format
JPEG
Microphone
Support
Build-in Speaker
Support
USB Function
USB-Disk/PC camera
Power interface
5V/1A
Battery
Build in 200mah
If you find that there are missing accessories in the package,
please contact our customer support email immediately.

PRODUCT STRUCTURE
①Microphone
②Reset point
③Mount socket
④3-inch screen
⑤Power socket
⑥HDMI slot
⑦TF card slot
⑧Up direction button
⑨Menu button
⑩Down direction button
⑪OK button
⑫Mode button
⑬Lock button
⑭Power button
⑮Charging indicator light
⑯Recording indicator light
INSTALLATION GUIDANCE
INSTALL THE FRONT CAMERA
WARNING: Please choose a good quality branded SD card
between 8GB and 32GB (Class 10 or UHS type 1) and format
the card within the setup menu before use. Please insert the
card in the right direction.

1. Insert the TF
card as shown
above, please
gently insert the
TF card into the
slot.
2. Mount the
front camera
- Clean the
front windscreen.
- Assemble the suction mount and front camera together.
- Remove the e protective plastic film from the suction pad, push
the suction cup onto the inner windshield in a suitable position
(Won't shade your vision while driving), press the suction bracket
handle to ensure that it is well fixed.
3. Connect the car original charger to the cigarette lighter.
Route the cables through the top ceiling and the A-pillar so that
it does not interfere with driving.

SETTING
-To enter the video setting menu:
Short press the Menu button when the camera is in video stand-
by mode.
-To enter the photo setting menu:
Short press the Menu button when the camera is in photo mode.
-To enter the system setting menu:
Short press the Menu button twice when you are in stand-by
mode.
How to modify the setting of these menus?
1. Press Up/Down to toggle through the sub-menus and press
OK to enter the sub-menu.
2. Press Up/Down to select an option and press OK to confirm.
3. Press Menu button to exit the setting menu.
Video Settings
Options
Resolution
1080FHD/1080P/720P
Loop recording
Off /1 Min/2 Min /3 Min /5 Min
Exposure
±2.0
Motion detection
On/Off
Record audio
On/Off
Date stamp
On/Off
G-sensor
Off /High /Medium/Low
WDR
On/Off
License plate
On/Off
Photo Settings
Options
Resolution
12M /10M/8M/5M/3M/2M/1.3M
Sequence
On/Off
Quality
Fine/Normal/Economy
Sharpness
Strong/Normal/Soft
White balance
Auto/Cloudy/Daylight /Tungsten
/Fluorescent
ISO
Auto/100/200
Exposure
±2.0

Anti-shaking
On/Off
Date stamp
On/Off
System Setting
Options
Park mode
On/Off
Date Time
YY/MM/DD
Auto Power off
Off /1 Min/2 Min
Screen saver
Off /5 Min /10 Min
Beep sound
On/Off
Frequency
50Hz/60Hz
Format
Cancel/OK
Default setting
Cancel/OK
Language
English, Dutch, French etc.
FUNCTION INTRODUCTION
Functions Introduction
1. Video/Photo/Replay Mode
Short press the Mode Button to switch the video/photo/replay
mode. If you are recording, press OK button to stop recording
first.
-In video mode, press OK to start/stop recording.
-In photo mode, press OK to shoot photos.

-In replay mode, press OK button to play/pause the video, press
the Up & Down direction button to switch videos.
2. Recording point
Red point will keep flashing while recording.
3. Lock sign
With lock sign, current file will be locked and can’t be overwritten.
When G-sensor detects a collision, it will lock the current file, you
can also lock the file manually by pressing the lock button on the
camera.
4. Microphone
With microphone sign, the audio will be recorded.
You can adjust the microphone on/off in the video setting menu.
5. G-sensor
When G-sensor detects a collision, it will lock the current file. You
can adjust the sensitivity of G-sensor between
off/high/medium/low in the video setting menu. Different kind of
sensitivities requires different gravity to activate the G-sensor.
6. Recording time of current video
7. Parking mode
With this mode on, it will automatically begin to record when the
vehicle manifests shake after the vehicle key is off. You can adjust
the parking mode on/off in the system setting menu.
8. Current Video resolution
You can change the current video resolution between 1080P and
720P in the video setting menu.
The higher resolution you set, the clearer and larger video it
captures.
9. Loop recording
Automatically overwrite the oldest files without locking.
You can change the video length of loop recording between
off/1min-5mins in the video setting menu.
10. Current date
The date will be shown on the video if you turn the date stamp
on.
11. TF card installed

It won’t shoot video or photo without TF card installed.
TROUBLE SHOOTING
PROBLEM
SOLUTION
Video Image is
blurred.
Remove the protective lens cover, clean
the lens, clean the windscreen!
I can only record
a few minutes of
videos on my
memory card.
Change the recording size (Video Length
function) to a smaller size. Increase the
size of the MicroSD card. Max 32GB.
The date & time
on my DASH
CAM is incorrect.
This time is the time when the product
leaves the factory. Please calibrate in the
settings.
Cannot remove
the memory
card.
With the card previously installed, you
now need to push the card further inwards
slightly, using your finger nail, until you
hear and feel a small latch. Use the edge
of a small coin if you have difficulty.
Release pressure and the card will spring
out sufficiently for you to take hold of it.
The SD card
cannot be read.
Use a good quality branded SD card
between 8GB and 32GB (Class 10 or UHS
type 1) and format the card within the
Setup menu.
Cannot insert the
memory card.
Micro SD card is very small and requires
delicate use. Align the card with the
diagram shown upon instruction and
insert the card until you feel a slight spring
resistance. You now need to push the
card, using your finger nail, until you hear
and feel a small latch. Release pressure
and the card will stay retained within the
device. Use the edge of a small coin if you
have difficulty.
I can't delete files
on my SD card
within the DASH
CAM.
Check to see if these files are 'protected',
if so, please follow instructions to 'un-
protect'.

The images
displayed in the
screen is upside
down.
Please ensure that the lens is in the correct
recording direction. If you mount the
DASH CAM on the dashboard, it will take
the wrong image. Please mount it on the
windshield with the diagram shown upon
instruction.
The DASH CAM
is no response.
Please reset the DASH CAM.
The screen
blanks after a few
minutes.
The screen saver is set to ON. Change
settings to OFF if required. Default setting
is off.
The battery only
last 10 seconds.
This battery can only reserve limited
power. Plug and play it. Based on the
design of power-off protection, the
battery needs to reserve a part of power
to support emergency recording function.
When I press the
MENU button
nothing happens.
This is normal during recording. Stop the
recording before pressing the MENU
button.
Find the DASH
CAM a little
heated after a
period time of
use.
The camera has metal frame with good
thermal conductivity for extended life of
cam. The Operating temperature is
designed between -10℃ to 60℃, so don’t
worry, it is a common phenomenon.
Unresolved
issues.
Reset the DASH CAM to the default
settings within the Setup Menu and try
again. Should the problem persist contact
us by support e-mail.
ANY PROBLEMS, please contact us by Email.
Here is the address:
US Customers: [e-mail]
EU Customers: [e-mail]