Phase Technologies SPF-15 Configuration guide

Thank you for choosing Phase Technology speakers.
We know there are a wide variety of choices available
today, and we sincerely appreciate your purchase of
our product. Phase Technology speakers are built to
exacting standards and will provide many years of
listening enjoyment.
Our speakers are the result of over five decades of
designing and manufacturing. We hold many key
patents in loudspeaker technology including the
soft-dome tweeter. Our mission, our passion is to
constantly advance the art and science of accurate
audio reproduction. Our dedication insures your new
speakers will accurately reproduce all the impact,
detail and delicacy of today’s digital technology.
Regardless of application, serious audiophile listening
or home theater,we recommend that you take the time
to read this manual thoroughly before connecting
speakers to your amplifier or receiver. In the highly
unlikely event that you should experience a problem
with set-up or operation, please contact one of our
authorized dealers for assistance, or contact us directly.
We trust that your new Phase Technology speakers will
enrich your enjoyment of music and movies beyond
your expectations.
Mounting bracket
Box contents
1 Speaker
T E C H N O L O G Y
SPF$15
Install instructions for SPF Outdoor models:

8650 College Boulevard / Overland Park, KS 66215 / (888)PHASE TK / www.phasetech.com / www.mseaudio.com
1. Unpack speaker.
5. Attach speaker to surface
using installer-supplied
fasteners.
6. Aim speaker by pointing
it up or down and/or
rotating it.
3b. If mounting speaker
offset from wiring point, run
wire out hole in wall and
behind base plate through 2
mm standoff gap between
base plate and wall. The
standoff gap accepts up to
18 gauge flat signal wire.
4. Choose a secure
mounting surface with
sufficient strength to reliably
hold the speaker.
3a. If mounting the speaker
directly over the wire,
ensure the base plate
covers the hole in wall.
7. Done!
2. Connect speaker wire
leads to the terminal screws
on the back of the base
plate. Polarity is indicated.
Install instructions for SPF-15, Page 2