Phenix fibersect.multi Operation manual

User Information: Connector and Ferrule Adapters
Phenix Fiber Optics, LLC
2011 N. 22nd Ave, Suite 3
Bozeman, MT 59718
[email protected]
[phone]
www.phenixfo.com
Introduction
The Phenix fibersect.multi® cuts the epoxy and fiber protruding from the face of the ferrule during
connector installation. Suitable adapters are available for bare ferrules and for fully assembled connectors.
Single and multi-fiber ferrule and connector adapters are discussed below.
Cut Distance Adjustment
The cut distance from the face of the ferrule is adjusted by rotating the Adjusting Ring. A tool is provided
that engages the two holes in the ring to facilitate rotation. Adapters are shipped with the cut distance
adjusted to ~200 µm. Rotate clockwise to cut closer to the face; rotate counterclockwise to cut further
away. Marks along the adapter ring perimeter represent increments of 25 µm. Any distance (0 to 600
µm+) can be set. Always change the cut distance in small steps and under controlled conditions to
minimize the chance of cutting into the ferrule. The saw will not be noticeably damaged if the ferrule is
accidentally cut, but will wear prematurely if done repeatedly. If the ferrule is cut, adjust the adapter to
increase cut length to avoid continued saw wear.
Adapter Orientation Adjustment
After adjusting for cut distance, adjust the rotational orientation of the adapter, as required and described
below.
Orientation Required
MT 0° Use the included Orientation Adjust tool to
MT 8° ensure that the ferrule slot is horizontal with the
engraved arrow pointed down.
LC-APC Insert a connector and use it to rotate the
SC-APC adapter until the connector’s latch is up.
LC-D Rotate the adapter until one connector is directly
above the other with their latches pointed to the
right.
FC-APC Insert a connector and use it to rotate the
adapter until the key slot is pointing up.
MDC Use the adapter extension to rotate the
MDC-J adapter so the ferrule holes are horizontal with
the extension below the ferrule holes.
1 of 2

Orientation Recommended
LC Insert a connector and use it to rotate the
SC adapter until the connector’s latch is up. The cut
will be parallel to the ferrule face in any
orientation, but this will make it more convenient
to insert.
Orientation Not Necessary
All adapters shown here do not require any adjustment and will cut parallel to the face of the ferrule in
any orientation.
LC Ferrule
SC Ferrule
ST Connector
FC Connector
P29504-4
S29504-5
M29504-14/15
SMA
Other Recommendations
Before inserting the connector or ferrule, ensure that bare fiber protruding from the face of the ferrule is
no more than 10 mm. A longer length will result in broken fibers. A length of 6 mm or less is
recommended to minimize breakage during handling. For best results, ensure that the bare fiber is
completely surrounded and supported by epoxy where the cut occurs. Because of the smaller bead of
epoxy used for single fibers, a cut close to the ferrule face may be necessary (20 µm to 80 µm). The
epoxy should be as fully cured/hardened as possible to provide strong support to the fiber as it is being
cut.
6/23/2020
2 of 2