Philips 8FF3FPW/05 Installation and operation manual

EN User manuals 1
PhotoFrame
8FF3FP Series
7FF3FP Series
6FF3FP Series
Register your product and get support at
www.philips.com/welcome

ENGLISH
1
Content
Content
Introduction
1. Important Information
1.1 Safety precautions and maintenance
1.2 Care of the PhotoFrame
1.3 Recycling
2. Your PhotoFrame
2.1 What’s in the Box
2.2 Control Buttons and Menu Navigation
2.3 Connections
2.4 Product Highlights
3. Getting started
3.1 Placing the Product
3.2 Connecting to the Mains
3.3 Turning on your PhotoFrame
3.4 Initial Setup
4. Using your PhotoFrame
4.1 View Photos
4.2 Find a Photo
4.3 Copy Photos
4.4 Delete Photos using the PhotoFrame
5. Use More of your PhotoFrame
5.1 Menu Navigation
5.2 Photo Menu
6. Settings
6.1 Slideshow Sequence
6.2 Transition Effects
6.3 Frequency
6.4 Collage
6.5 Background Color
6.6 Brightness
6.7 Language
6.8 Memory Card
6.9 Timer Function (Auto On/Off)
6.10 Check the Status of your Photoframe
6.11 Rotate Function (Auto Tilt)
6.12 Beep On/Off
6.13 Key Help
7. Technical data
8. Frequently asked questions
9. Service and Warranty
3
3
3
4
5
5
6
6
7
8
8
8
8
8
12
12
12
13
14
15
15
15
19
19
19
20
21
21
22
22
23
23
25
26
26
27
28
30
31

2Content

1.1 Safety precautions and
maintenance
Read and follow these instructions when
connecting and using your PhotoFrame:
• To protect your display from possible damage,
do not put excessive pressure on the LCD
panel.When moving your PhotoFrame,
grasp the frame to lift; do not lift the it by
placing your hand or fingers on the LCD
panel.
• Unplug the PhotoFrame if you are not going
to use it for an extensive period of time.
• Unplug the PhotoFrame if you need to clean
it with a slightly damp cloth.The screen may
be wiped with a dry cloth when the power
is off. However, never use alcohol, solvents or
ammonia-based liquids.
• Consult a service technician if the
PhotoFrame does not operate normally
when you have followed the instructions in
this manual.
• The casing cover should be opened only by
qualified service personnel.
• Keep the PhotoFrame out of direct sunlight
and away from stoves or any other heat
source.
• Keep the PhotoFrame dry.To avoid electric
shock, do not expose it to rain or excessive
moisture.
Introduction
Philips digital PhotoFrame can be placed either
vertically or horizontally to fit the photos on
display.You can place it somewhere in a room
for a continuous display by connecting it to the
mains power supply.
1. Important
• When positioning the PhotoFrame, make
sure the power plug and outlet are easily
accessible.
• To avoid the risk of shock or permanent
damage to the set, do not expose the
PhotoFrame to rain or excessive moisture.
1.2 Care of the PhotoFrame
1Do not drop
PhotoFrame is a complicated electronic
device and cannot withstand shock from
being dropped.
2Do not expose to moisture
PhotoFrame is neither moisture proof nor
moisture resistant. Exposing it to moisture
or liquid of any kind will very likely damage
your PhotoFrame.
3Do not hit or scratch
The LCD panel of PhotoFrame is made of
glass and is therefore sensitive to abnormal
force and sharp edges.
4Screen cleaning
Use only a dry soft cloth to clean your
screen.
3
Important
ENGLISH

5Keep the stand clear from cables
Make sure the stand of your PhotoFrame
is clear from cables as cables could pull the
stand out of PhotoFrame to the floor.
6Temperature and humidity limitations
Operating temperature:
0° ~ 40° (Celsius) / 32° ~ 113° (Fahrenheit)
Humidity: 20% ~ 80%
1.3 Recycling
• To minimize harm to the environment, the
batteries supplied with the PhotoFrame do
not contain mercury or nickel cadmium. If
possible, when disposing of batteries, use
recycling means available in your area.
• The PhotoFrame uses materials that can be
recycled.To minimize the amount of waste
in the environment, check your area for
companies that will recover used televisions
for dismantling and collection of reusable
materials, or contact your dealer for recycling
tips.
• Please dispose of the carton and packing
material through the proper waste disposal
management in your area.
4Important

5
Your PhotoFrame
ENGLISH
2. Your PhotoFrame
2.1 What’s in the box
Digital PhotoFrame Power adaptor USB Cable to PC
(male B type plug)
Quick start guide
Digital photo display 7FFI series
Connect
2Setup
3Enjoy
1
Quick start guide User manual and Auto Run
software on CD
What else you’ll need
AC
Power outlet Digital Photos on memory card or PC

2.2 Control Buttons and Menu
Navigation
• Use your PhotoFrame by pressing the control
buttons in the back.
• The control buttons and instructions are
shown at the bottom of the menu screen.
Use the navigation controller to move
between the menus. Move it left and right to
cycle through the menu tree.
2.3 Connections
2.3.1 Memory Card
Photo display (underside)
A. CF Card
B. SD/ MMC /MS / xD Card
Inserting a memory card:
• Insert the memory card into the slot in the
frame.
• For xD, SD, MMC, MMC+, or Memory Stick
cards slide the card until it locks in place.
• Push the USB drive in the slot.
• After a few seconds, photos on the memory
card will display and a slideshow will start.
DO NOT remove the memory card immediately
after inserting it in to the PhotoFrame or when
PhotoFrame is counting the Photos.Wait until
the screen is stable
Removing a memory card:
• To remove the xD, xD, SD, MMC, or Memory
Stick card, push the card again to unlock and
then pull out the card.
Note:
To be able to delete photos from the memory
card it must NOT be locked.To unlock the card
follow the manufacturer’s instructions.
2.3.2 USB Connections
For Windows PC (XP & Vista):
• Connect PhotoFrame to a PC via the supplied
USB cable where it will be recognized as a
mass storage device.
6Your PhotoFrame

• For installation and more details about his
application, follow instrustions in user manual
on CD.
Note:
The 5.6” model does not support a connection.
PhotoFrame
PhotoFrame
PC
For Mac System: (OS X):
• Connect PhotoFrame to the Mac via a USB
cable where it will be recognized as a mass
storage device.
• Select the photos to be transferred and copy
them directly under the root directory of
the storage card. (Only JPEG formatted
images supported).
• Disconnect the USB cable
Note:
Do not disconnect PhotoFrame when copying
or transferring Photo between PC and
PhotoFrame.
2.4 Product highlights
The PhotoFrame is designed to be flexible and
convenient to use and it provides the following
features:
• High pixel density for sharp and crisp photo
display.
• View photos directly from memory cards
– no PC needed.
• Auto-Tilt function so portrait and landscape
photos are displayed in the best possible way.
• Rotating stand for best possible way of
viewing photos.
• Clock and alarm.
7
Your PhotoFrame
ENGLISH

3. Getting started
3.1 Placing the Product
The PhotoFrame should be placed on a flat
surface and close to a power socket. Keep it
away from high temperatures and high levels of
moisture
3.2 Connecting to the mains
Connect the supplied power cable from
PhotoFrame to a power outlet.
Note:
For safety reasons and best stability Philips
recommend to adjust the stand with the angle
defined by the two click positions. Using other
positions may cause the PhotoFrame to fall and
it is the responsibility of the user.
3.3 Turning on your PhotoFrame
Press the power button.
3.4 Initial Setup
3.4.1 Setting the Language
Press the Mode button to toggle to the Main
Menu, select the Setting and navigate Down
to Language.
1Navigate Up and Down to select your
preferred language (select between English,
French, Spanish, Italian, German, Russian,
Dutch, Danish, Simplified Chinese and
Japanese)
2Press the Play/OK button to confirm
your selection.The new setting will be effective
immediately.
Press the Mode button to leave this menu and
play the slideshow.
3.4.2 Access Menus
There are two ways to access the menu.To
quick access the menu while you are viewing
photos, press the Menu button to see the menu
options for photo editing or slideshow settings.
To access the menu options starting from the
main menu:
1Press the Mode button.
2Navigate Down to highlight the required
menu (Clock, Photos and Settings).
3Press Play/OK to access the menu.
To exit from the menus press the Mode
button again to return to the slideshow.
8Getting Started
1
3
2