Philips DVD-622 Quick start guide

1. Introduction
The upgrade version of this software is Version 1.23
__________________________________________________________________
2. Key Features added in this software version
This software version includes:
• Fix the problems
o MP3-CD files cannot be read
o MP3-CD files cannot be completely read
__________________________________________________________________
3. Software Upgrade Disc Preparation
Tools Required
You will need the following items :
• PC (Pentium III 300MHz processor or higher)
• CD-R/RW writer and writing application software
• Blank CD-R or CDRW disc
• Broadband / High speed internet connection
__________________________________________________________________

4. How to download the software to your computer
1) Right mouse button click on the file and click ‘Save Target As… ’ to save
the zip file into your PC.
2) Unzip the .zip file and extract files into your PC.
__________________________________________________________________
5. Software Version Verification Procedure
It is important to write down the system version information of your set before you
start the upgrade procedure. This information is also useful in case you need to
call Philips Customer Care Center.
• Open the tray door of the player and press “display” or “onscreen” on
the remote control and check the software version.
__________________________________________________________________
6. Steps to upgrade DVD622
1. Rename files to “build.img” and “upgrade.ver” if it is not already named in
this manner.
2. Burn the files to blank CD R or CDRW, using the following settings:
· File System CD-ROM ISO Level 2
· Mode 1/2/XA
· Character set ISO 9660
· Finalised, single session
· Write speed slow (e.g. 2x, 4x)
Finalize the disc. (The application may do this automatically.)

NOTE : Packet writing application for drag & drop copying cannot be used
for creating an upgrade disc. Use only a dedicated CD writing application
allowing ‘disc at once’ recording.
No UDF setting as well.
3. Put the CD-R into the player.
4. Once the OSD menu appears, press “OK” to start upgrade. Remove the CD-R
when the tray opens automatically. Upgrading of the software will continue.
5. Once the software is upgraded, player will be restarted automatically.
6. The whole process should not take more than 5 minutes.
Caution: Do not unplug or power off the set until upgrade is completed.
__________________________________________________________________
7. After the upgrade
Do confirm the software version by checking the system version.
Please follow the procedure described in the section “Software Version
Verification Procedures”.
__________________________________________________________________
8. Software History
Software Version 1.23
• Fix the problems
o MP3-CD files cannot be read
o MP3-CD files cannot be completely read