Philips SP9820 User manual

www.philips.com/support/ifu-lux
BC
SP9820
Tripleheader shaver

SP9820/88
6
5
4
19
18
17
16
15
14
13
12
9
8
7
11
10
1
2
3

empty page before TOC

English 6
Español 33

English
IMPORTANT SAFETY
INSTRUCTIONS
When using an electric product, basic
precautions should always be followed,
including the following:
Read all instructions before using this
product.
DANGER
To reduce the risk of electric shock:
-Do not reach for a corded product that has
fallen into water. Unplug immediately from
the power outlet.
-Keep the power cord dry.
-Do not place or store the product where it
can fall or be pulled into a tub or sink. Do
not place or drop the product into water or
other liquid.
-Except when charging, always unplug this
product from the power outlet immediately
after use.
-Remove power cord from power outlet and
product before cleaning.
WARNING
To reduce the risk of burns, fire, electric
shock, or injury to persons:
6English

-Close supervision is required when this
product is used by, on, or near children, or
persons with limited physical, sensory, or
mental capabilities or invalids.
-Use this product only for its intended
household use as described in this manual.
Do not use attachments not recommended
by Philips North America LLC.
-Never operate this product if it has a
damaged power cord, if it is not working
properly, after it has been dropped or
damaged, or after the product or power
cord has been dropped into water. For
assistance call 1-800-243-3050.
-Keep the power cord away from heated
surfaces.
-Never drop or insert any object into any
opening.
-Do not use the power cord in or near a
power outlet that contains an electric air
freshener to prevent damage to the power
cord.
-Do not use product outdoors or operate
where aerosol (spray) products are being
used or where oxygen is being
administered.
-Always check cutters, cutting unit and
guards before using the product. Do not use
the product if cutters, cutting unit or guards
are damaged, as injury may occur.
7
English

-Always attach power cord to product first,
then to power outlet. To disconnect, set all
controls to 'off' position. Then remove
power cord from power outlet.
-Plug power cord directly into power outlet.
Do not use an extension cord.
-Unplug power cord before plugging in or
unplugging the product.
-Only use the power cord and other
accessories supplied with the product.
-Do not attempt to open the product to
remove or replace the built-in rechargeable
battery.
-The batteries used in this product may
present a fire or chemical burn hazard if
mistreated. Do not disassemble, heat above
100°C (212°F) or incinerate.
IMPORTANT: The power plug contains a
transformer. Do not cut off the power plug to
replace it with another plug as this will cause a
hazardous condition.
SAVE THESE
INSTRUCTIONS
Contents
IMPORTANT SAFETY INSTRUCTIONS___ 6
General description (Fig. 1)_______________ 9
Introduction______________________________ 10
The display_______________________________ 10
Charging__________________________________ 14
8English

Using the shaver_________________________ 15
Using click-on attachments______________ 19
Travel lock________________________________ 22
Cleaning and maintenance______________ 22
Replacement_____________________________ 27
Storage___________________________________ 29
Accessories_______________________________ 29
Assistance________________________________ 30
Disposal__________________________________ 30
Full Two-Year Warranty__________________ 31
45-DAY MONEY-BACK GUARANTEE____ 32
General description (Fig. 1)
1 Protection cap for click-on skin cleansing
brush
2 Click-on skin cleansing brush
3 Skin cleansing brush attachment holder
4 Power plug
5 Small plug
6 Travel case
7 Socket for small plug
8 Unplug for use symbol
9 Replacement reminder
10 Notification symbol
11 Cleaning reminder
12 Travel lock symbol
13 Battery charge indicator
14 Battery charge percentage
15 Personal comfort settings bar
16 + and - buttons for personal comfort
settings
17 On/off button
18 Shaving unit with hair chamber
19 Click-on precision trimmer
9
English

Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that Philips
Norelco offers, register your product at
www.norelco.com/register.
The display
Note: Remove any sticker or protective foil
from the display before using the product.
Charging
When the shaver is charging, the battery
charge indicator on the shaver flashes white.
The battery charge is indicated by the battery
charge percentage flashing on the display,
which is shown when the shaver is moved.
Quick charge: After approx. 5 minutes
charging, the shaver contains enough energy
for one shave.
Battery fully charged
When the battery is fully charged, the battery
charge indicator lights up white continuously.
Note: When the battery is full, the display
switches off automatically after 15 minutes.
The battery charge percentage lights up white
continuously, when the shaver is moved.
10 English

Battery low
When the battery is almost empty, the battery
charge indicator flashes orange and the shaver
beeps. At this point there is enough energy left
for one shave..
Remaining battery charge
The remaining battery charge is indicated by
the battery charge percentage shown on the
display.
Personal comfort settings
The shaver has a feature that allows you to
personalize your settings. Depending on your
personal shaving needs, choose between
three settings, from low to high: slow: for an
even more skin-friendly shave, medium: for a
standard thorough shave, and fast: for a high-
powered shave. When you press the button on
the left or right of the display, the segment of
the personal comfort settings bar that lights up
shows the currently selected setting. To select
a lower or higher setting, press the button on
the left or right of the display.
11
English

Cleaning reminder
Clean the shaver after every use for optimal
performance (see 'Cleaning and maintenance').
When you switch off the shaver, the cleaning
reminder flashes to remind you to clean the
shaver.
Travel lock
3 sec.
When you are going to travel, you can lock the
shaver to prevent it from accidentally turning
on.
Replacement reminder
For maximum shaving performance, replace
the shaving heads every year (see
'Accessories'). The shaver is equipped with a
replacement reminder, which reminds you to
replace the shaving heads. The shaver beeps,
the replacement reminder lights up, and the
arrows flash to indicate that you have to
replace the shaving heads.
Note: After replacing the shaving heads, you
can reset the replacement reminder by
pressing the on/off button for 7 seconds. If you
do not reset the replacement reminder, the
shaver resets automatically after 9 shaves.
12 English

’Unplug for use’ reminder
The ‘unplug for use’ symbol flashes to remind
you to disconnect the shaver from the wall
socket before you can switch it on.
Notification symbol
Overheating
If the shaver overheats during charging, the
notification symbol flashes. When this
happens, the shaver stops charging
automatically. Charging continues once the
temperature of the shaver has decreased to
the normal level after approx. 10 minutes.
Blocked shaving heads
If the shaving heads are blocked, the
notification symbol lights up red continuously.
The replacement reminder and the cleaning
reminder alternately flash white and the
shaver beeps. In this case, the motor cannot
run because the shaving heads are dirty or
damaged. If the shaving heads are dirty, you
have to clean them. If the shaving heads are
damaged, you have to replace them.
13
English

Charging
-Charging, recharging, or using the product
at temperatures below 40°F (4.5°C) or
higher than 95°F (35°C) adversely affects
the lifespan of the battery.
-Do not charge the shaver in a pouch or
travel case.
-The power plug transforms 100-240V AC to
less than 24V DC.
Charge the shaver before you use it for the first
time and when the display indicates that the
battery is almost empty.
Charging takes approx. 1 hour. A fully charged
shaver has a shaving timeof up to 60 minutes.
Note: You cannot use the shaver while it is
charging.
Quick charge
After approx. 5 minutes of charging the shaver
contains enough power for one shave.
Charging with the power cord
1Make sure the shaver is switched off.
2Put the small plug in the shaver and
connect the power plug to any 100V to
240V AC outlet. Use only the power cord
provided.
The display of the shaver indicates that the
shaver is charging.
3After charging, remove the power plug from
the wall outlet and pull the small plug out of
the shaver.
14 English

Note: An adapter plug may be necessary for
cord usage in some foreign countries. Use an
attachment plug adapter of the proper
configuration for power outlet.
Using the shaver
Always check the shaver and all accessories
before use. Do not use the shaver or any
accessory if it is damaged, as this may cause
injury. Always replace a damaged part with
one of the original type.
This symbol indicates that the shaver can be
used in the bath or shower.
-Use this shaver for its intended household
use as described in this manual.
-For hygienic reasons, the shaver should
only be used by one person.
-Trimming is easier when the skin and hair
are dry.
Note: This shaver is waterproof. It is suitable
for use in the bath or shower and for cleaning
under the tap. For safety reasons, the shaver
can only be used without charging cord.
Put it to the test
-21 Day Trial and Conversion Process. It is a
fact that your skin and beard need time to
adjust to a new grooming system.
15
English

-Use your new shaver exclusively for 3 weeks
to fully enjoy the closeness of a Philips
Norelco shave.
-At first you may not get as close a shave as
you expect, or your face may even become
slightly irritated. This is normal since your
beard and skin will need time to adjust.
Invest 3 weeks and you'll soon experience
the full joy of your new shaver.
-Stick with it! If you alternate shaving
methods during the adjustment period, it
may make it more difficult to adapt to the
Philips Norelco shaving system.
-If you are still not convinced after 21 days,
Philips Norelco will refund you the full
purchase price as long as the request is
received within 45 days of purchase.
Switching the shaver on and off
1To switch on the shaver, press the on/off
button once.
The battery charge percentage lights up for
a few seconds.
2To switch off the shaver, press the on/off
button once.
The battery charge percentage lights up for
a few seconds and shows the remaining
battery charge.
16 English

Shaving
Shaving tips
-For the best results on skin comfort, pre-
trim your beard if you have not shaved for 3
days or longer.
-Select your personal comfort setting.
Dry shaving
1Switch on the shaver.
2Move the shaving heads over your skin in
circular movements to catch all hairs
growing in different directions. Make sure
each shaving head is fully in contact with
the skin. Exert gentle pressure for a close,
comfortable shave.
Note: Do not press too hard, this can cause
skin irritation.
3Switch off and clean the shaver after each
use.
The display lights up for a few seconds to
show the remaining battery charge.
Wet shaving
For a more comfortable shave, you can also
use this shaver on a wet face with shaving
foam or shaving gel.
1Apply some water to your skin.
17
English

2Apply shaving foam or shaving gel to your
skin.
3Rinse the shaving unit under the tap to
ensure that the shaving unit glides smoothly
over your skin.
4Switch on the shaver.
5Move the shaving heads over your skin in
circular movements to catch all hairs
growing in different directions. Make sure
each shaving head is fully in contact with
the skin. Exert gentle pressure for a close,
comfortable shave.
Note: Do not press too hard, this can cause
skin irritation.
Note: Rinse the shaving unit regularly to
ensure that it continues to glide smoothly
over your skin.
6Dry your face.
7Switch off the shaver and clean it after each
use.
Note: Make sure that you rinse all foam or
shaving gel off the shaver.
18 English

Using click-on attachments
Removing or attaching click-on attachments
1Make sure the shaver is switched off.
2Pull the attachment straight off the shaver.
Note: Do not twist the attachment while you
pull it off the shaver.
3Insert the lug of the attachment into the slot
in the top of the shaver. Then press down
the attachment to attach it to the
shaver(‘click’).
Using the precision trimmer attachment
You can use the precision trimmer attachment
to touch up your beard, sideburns and
mustache.
1Attach the attachment to the product
('click').
2Switch the product on.
3Hold the precision trimmer perpendicular to
the skin and move it downwards while
exerting gentle pressure.
4Switch off and clean the product after each
use.
19
English

SP9820/88 only:
Using the cleansing brush attachment
Note: For better shaving results, use the click-
on cleansing brush attachment before shaving.
Use the rotating cleansing brush with your
daily cleansing cream. The cleansing brush
removes oil and dirt, contributing to a healthy
and oil-free skin. We advise you to use it no
more than twice a day. Start with the lowest
personal comfort setting to familiarize yourself
with the attachment.
Do not use the attachment on damaged or
irritated skin or on wounds.
1Place the attachment on the attachment
holder.
2Attach the brush to the product ('click').
3Moisten the brush with water.
Note: Do not use the product with a dry
cleansing brush attachment, as this can
irritate the skin.
20 English