Philips Dynalite DDNG100BT User manual

features
Single Phase supply –230 +/- 14% 50/60Hz 0.1A
1 x RS485 Port –Dynet lighting control.
1 x 10/100BaseT - Ethernet port
Powerful Internal PLC - Custom scripts can be written
to provide process control based on conditional logic.
DIN Rail Mounting - 12 Units wide.
Warning –This is a class A product. In a domestic environment this product
may cause radio interference in which case the user may be required to take
adequate measures.
Read Instructions –We recommend that you read this Instruction Manual prior
to commencement of installation.
Special Programming –This device will only operate in basic modes unless
programmed via a computer. If programming is required, contact your local
agent for details. Once the data cable is connected to the devices, the factory
default settings will allow any control panel to operate all channels in all
controllers.
Mounting Location –Install in a dry, well-ventilated location.
Data Cable –Use screened, stranded RS485 data cable with three twisted
pairs. Segregate from mains cables by 300mm. Connect devices in a ‘daisy
chain’. Do not cut or terminate live data cables.
Power Sources –This device should only be operated from the type of supply
specified on the front panel. This device must be earthed.
Megger Testing –Do not megger test any circuitry connected to the control
system, as damage to the electronics may result.
DDNG100BT
10/100BaseT Ethernet
Installation Manual
Warning
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS DEVICE TO RAIN OR MOISTURE.
DO NOT ENERGISE UNLESS THE FRONT COVER IS IN PLACE.
THIS DEVICE MUST BE EARTHED.
INSTALLATION, PROGRAMMING AND MAINTENANCE MUST BE
CARRIED OUT BY QUALIFIED PERSONNEL.
Electrical diagram

connecting data cable
product specifications
Supply: 230 +/- 14% 50/60Hz Single Phase
Serial Port 1: 1 x 10/100BaseT Ethernet, consisting of 1 x RJ45 socket
Serial Port 2: 1 x RS485 unterminated, consisting of 1 x RJ12 socket & 1 x 5 way terminal block
RS485 Data Formats: DyNet, DyNet II
User Controls: Service Switch, Diagnostic LED
Internal Controls: Programmable Logic Controller, 64 Tasks
Operating Environment: 0º to 50ºC ambient temperature, 0% to 95% RH non condensing
Power Consumption: 450mA from the DyNet network at 12VDC
Compliance: CE, C-Tick
Construction: Polycarbonate DIN Rail enclosure (12 unit)
Dimensions: H 93mm x W 211mm x D 75mm
Weight: 0.86kg
DDNG100BT Installation Manual Rev B.doc Specifications subject to change without notice
Philips Dynalite manufactured by WMGD Pty Ltd (ABN 33 097 246 921) Unit 6, 691 Gardeners Road Mascot NSW 2020 Australia Tel: [phone] Fax: [phone]
E-Mail: [e-mail] Web: Philips.com/dynalite
1. Mount the device on a DIN rail inside an appropriate enclosure
2. Connect supply cables feed from the appropriately rated protection.
3. Connect Ethernet and Dynet data cables to the device as per label on device.
4. Power up device once all termination have been re checked.
5. The unit will need to be configured using Envision commissioning tool
Installation steps