Philips HP4878/00 User manual

Powerprotect Salon 2000
HP4878, HP4877, HP4876

2

3

4

ENGLISH 6
POLSKI 13
ROMÂNĂ 21
РУССКИЙ 28
ČESKY 37
MAGYAR 44
SLOVENSKY 51
УКРАЇНСЬКА 58
HRVATSKI 66
EESTI 73
LATVISKI 80
LIETUVIŠKAI 87
SLOVENŠČINA 94
БЪЛГАРСКИ 101
SRPSKI 109
HP4878, HP4877, HP4876

Introduction
The Philips Powerprotect Salon has been specially designed to meet
your personal needs, giving you beautiful, shiny and healthy hair.
Scientific tests have shown that drying at a too high temperature can
lead to overdrying. Hair that has been overdried, feels coarse and looks
dull and frizzy.Whereas normal hairdryers can heat up the hair to very
high temperatures (approx. 80cC), the Powerprotect Salon 2000
features the Power Protect System.This system offers gentle drying at a
lower and caring temperature of 57cC, reducing the risk of overheating
the hair. Combined with an ultra strong airflow, the system dries your
hair ultra quickly, giving it the lustre, body and richness you love.
For more information on this hairdryer or any other Philips beauty
product, visit our web site: www.philips.com/beauty
General description
AAir inlet grille
BRocker switch for temperature settings
-‡Quick-Dry setting
-·Protect setting
-—Cool setting
CAirflow and on/off slide
- O = off
- I = Low airflow especially intended for styling
- II = Medium airflow for drying and styling
- III = Ultra strong airflow for fast drying
DHanging loop
EVolume diffuser (HP4877 and HP4878 only)
FConcentrator
GProfessional haircare set (HP4878 only)
- Round brush
- Comb
- Hairclips
- Pouch
ENGLISH6

Important
◗Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
◗Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc.
When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the hairdryer is
switched off.
◗For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30mA in the electrical circuit supplying the
bathroom.Ask your installer for advice.
◗Keep the appliance out of the reach of children.
◗Never block the air grilles.
◗If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they
are not blocked by fluff, hair, etc.
◗Always switch the appliance off before putting it down, even if it
is only for a moment.
◗Noiselevel: L= 86 dB(A) re 1pW
Using the appliance
Drying
1Put the plug in the wall socket.
2Switch the appliance on by setting the airflow slide to position I, II
or III.
3Select the desired airflow speed by setting the airflow slide to
position I, II or III (fig. 1).
O = Off
I = Low airflow especially intended for styling
II = Medium airflow for drying and styling
III = Ultra strong airflow for fast drying
ENGLISH 7

4Select the desired temperature setting by pressing the rocker
switch.
The Quick-Dry setting
◗‡The Quick-Dry setting enables you to dry shower-wet hair
very quickly (fig. 2).
It is recommended to use the Quick-Dry setting only on shower-wet
hair and to select the Protect setting when the hair is almost dry in
order to reduce the risk of overdrying.
The Protect setting
◗·The Protect setting gently dries the hair at a caring
temperature of 57cC (fig. 3).
The Cool setting
◗—The Cool setting fixes the style you have created (fig. 4).
For long-lasting styling results, set the rocker switch to the Cool setting
and direct the cool airflow at your hair to fix your style.
5Dry your hair by making brushing movements with the hairdryer
at a small distance from the hair (fig. 5).
6Select the highest airflow speed (III) in combination with the
Quick-Dry or Protect setting for ultra-quick drying.
7Select a lower airflow speed (I-II) for drying short hair or styling
your hair.
Attachments
Concentrator
The concentrator enables you to direct the airflow straight at the brush
or comb with which you are styling your hair.
1Connect the concentrator by simply snapping it onto the
appliance (fig. 6).
2Switch the appliance on by setting the airflow slide to position I, II
or III.
ENGLISH8

3While you are drying your hair with the concentrator, you can
use a brush or comb to style your hair (fig. 7).
4Disconnect the concentrator by pulling it off the appliance.
Volume diffuser (HP4877 and HP4878 only)
The volume diffuser has been specially developed to gently dry both
straight and curly or wavy hair.
◗The volume diffuser emits a gentle airflow and allows you to give
your style volume and bounce (fig. 8).
1Connect the diffuser by simply snapping it onto the appliance.
Disconnect it by pulling it off (fig. 9).
◗To add volume at the roots, insert the pins into your hair in such
a way that they touch your scalp (fig. 10).
2Make rotating movements with the appliance to distribute the
warm air evenly through your hair (fig. 11).
Curly or wavy hair
◗(fig. 12).
- When you are styling curly or wavy hair, hold the diffuser at a
distance of 10-15 cm from your head to let the hair dry gradually.
- In the meantime you can style your hair with your free hand or
with a comb.
- You can also scrunch locks of hair in your hand to shape the curls
and waves while drying.This will prevent the curls from sagging or
becoming frizzy.
Long hair
◗To dry long hair, you can spread out locks of hair on top of the
diffuser (fig. 13).
◗Alternatively, you can comb the hair downwards with the pins of
the diffuser while drying (fig. 14).
ENGLISH 9

Styling and drying tips
Here is one style you can create easily and gently with the Philips
Powerprotect Salon 2000 hairdryer. As you become more familiar with
the appliance, you will discover many other ways to create great styles.
Just use your imagination!
1After washing and conditioning your hair as usual, start drying it
by dabbing the wet hair with a towel, then comb it through
carefully.
2Place the diffuser (HP4877 and HP4878 only) in your hair so that
the tips of the air pins touch your scalp. By making circular
movements with the diffuser, the hair will be lifted towards the
base of the diffuser and the air pins will dry the hair from the
roots upwards.This will add more volume to your hair. Continue
drying until your hair is dry at the roots.
3Set the airflow to a lower position and continue drying until your
hair is completely dry. Use a comb or brush to style your hair in
the desired way while drying.
4To create volume at the hair ends, hold the diffuser in horizontal
position and place some locks of hair on the base of the diffuser
between the air pins and leave them there for a while.The gentle
airflow will prevent your curls or waves from being blown out of
style while drying.
5Finish off with the cool airflow to fix your style.
Set the rocker switch to the Cool setting and direct the cool airflow at
your hair to fix your style.
Cleaning
Always unplug the appliance before cleaning it.
Never rinse the appliance with water.
◗The appliance can be cleaned with a dry cloth.
◗The attachments can be cleaned with a moist cloth or by rinsing
them under the tap.
ENGLISH10