for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem Possible cause Solution
come out of the
soleplate.
Scale has built up inside the
appliance because it has not
been descaled regularly.
Descale the appliance (see chapter
You have put chemicals or
little steam.
Wait until the iron ready light stays on
Water leaks from
the soleplate.
used it for a long time.
the garment and press the steam trigger.
of the soleplate.
board cover
droplets on the
Steam has condensed on the
ironing board cover after a
board cover is not designed
rate.
Replace the ironing board cover if the foam
use a layer of felt material in the board cover
not tightened properly.
knob to make sure it is tightened.
Contact an authorised Philips service centre
not heat up and
to perform the descaling
about after every one month
or after every 10 ironing
sessions.
generator
produces a
pumping sound.
Water is pumped into the
Contact an authorised Philips service centre.
8
4239_000_8864_1_DFU Booklet_Simple_A5_v4.indd 8 10/8/13 11:13 AM
