This portable DVD player is designed with a
built-in lithium battery to supply power to the
player when you are on travel.
1Slide the POWER switch to the OFF position
(charging of the DVD player only possible in
the power-off mode).
2Connect the supplied power adaptor cord (or
the car adaptor) to the player and AC mains
(or the car cigarette lighter outlet) to start
charging.
➜The CHG indicator turns red .
➜When the battery is fully charged, the
indicator turns off.
3Disconnect the power adaptor cord (or the
car adaptor) when the CHG indicator turns
off.
Notes:
– You can also connect the supplied power adaptor
cord (or the car adaptor) to the player and AC
mains (or the car cigarette lighter outlet) directly
wherever possible.
Charge your battery
1
Quick start guide
Philips Portable DVD Player PET722/PET726
3OPEN HERE
1Slide the POWER switch to ON to switch on
the DVD player.
➜The POWER indicator turns on.
2Gently push the front panel as shown to open
the disc compartment.
4Remove the protective card (if any) and load a
disc with the label side facing up.
5Pull the front panel back to close the disc
compartment. Playback will start automatically.
If not, press 2;.
6To stop playback, press 9.
2Enjoy (Disc operation)
Note:
– Once the battery is fully discharged, immediately
recharge it (regardless of whether you plan to use
the battery or not) in order to maximize the
battery life.When the power is low, the battery icon
will be shown on the upper-left corner of the TFT
for warning.
2Enjoy (AV OUT)
Connecting additional equipment (TV for
example)
1Connect the AV OUT socket on the set to the
video and audio sockets on a TV as shown
directly.
2Switch on the TV and set to the correct video-
in channel.
➜You can consult the owner's manual of your
TV. (If your TV does not have Audio and Video
inputs, you will need to purchase a RF
modulator. Please consult your dealer.)
WK749
White
Red
Yellow
Not supplied
