Philips TAS2505 User manual

ww w.philips.com/support
User manual
Register your p roduct and get suppo rt at
TAS2505

EN 1
Contents
1 Important 2
Safety 2
2 Your wireless speaker 3
Introduction 3
What's in the box 3
Overview of the speaker 3
3 Get started 4
Charge the built-in battery 4
4
4 Play from Bluetooth devices 5
Play from Bluetooth devices 5
Control playback 5
Control phone call 5
Pairing for stereo mode 5
5 Product information 6
6 Troubleshooting 7
General 7
Bluetooth 7
7 Notice 8
Compliance 8
Care of the environment 8
FCC Statement 8
Trademark notice 9

2EN
1 Important
Warning
Never remove the casing of this product.
Never lubricate any part of this product.
Never place this product on other electrical equipment.
Keep this product away from direct sunlight, naked
flames or heat
Read these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
Only use attachments/accessories specified
by the manufacturer.
Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
The battery shall not be exposed to
excessive heat such as sunshine, fire or the
like
Apparatus shall not be exposed to
dripping or splashing.
Do not place any sources of danger on the
apparatus (e.g. liquid filled objects, lighted
candles).
Note
The type plate is located on the bottom of the
apparatus.

3EN
2 Your portable
speaker
Congratulations on
welcome to Philips! To fully benefit from the
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this speaker, you can enjoy audio from
Bluetooth-enabled devices or other external
devices.
What's in the box
Check and identify the contents of your
package:
Speaker
USB cable for charging
Quick start guide
Safety sheet
Worldwide warranty
Lanyard
Overview of the speaker
4
Total vol 0 to 16 levele. short press for
vol down/up one level, press & hold for
continue down/up.
Voice prompt for vol reach Max or Min
vol level.
5 DC IN
Recharge the built-in battery.
1
Turn the speaker on or off.
Press and hold 2 second for power on,
with voice prompt, LED blue flashing.
Press and hold 2 second for power off,
with voice prompt, LED off.
Solid blue once paired.
Press and hold 5 second to clear pairing
information / to enter pairing mode, fast
flashing blue light.
Automatically turn off in 15mins without
connection.
3
Press to pause or resume play, press
twice to play the next track.
Music play/pause when there is an
incoming/outgoing call, flashing Blue slow,
and resumes when your phone call ends.
Press to answer an incoming call. Press
and hold for two seconds to reject an
incoming call. During a call, press to end
the current call. During a call, press and
hold for two seconds to transfer the call
to your mobile device.
1
2
5
3
4
2
Short press for turn on music light.
Short press again for turn off music light.
Fast flashing blue light for pairing.
Slow flashing blue light to reconnect the
last connected device automatically.
your purchase, and

4EN
3 Get started
Always follow the inst ructions in this chapter in
sequence.
Charge the built-in battery
The speaker is powered by a built-in
rechargeable battery.
Note
· Before use, fully charge the built-in battery.
· The micro USB socket is for charging only.
· It takes you approximately two and a half hours to fully
charge the battery.
· Rechargeable battery has a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
Connect the USB cable between
the DC IN socket on the speaker, and
a USB socket on a computer.
The LED indicator indicates the battery status.
Under charging Fully charged
"OFF"
mode
Solid red Off
"Bluetooth "
mode
Turn on/off
To turn the speaker on，press and hold
"Power" for two seconds, with power on
voice prompt and Blue LED indicator starts
blinking.
To turn the speaker off, press and hold
"Power" for two seconds again, with power
off voice prompt and LED off.
Auto off in 15 Minutes if no Bluetooth
connection
Solid red Solid blue

5EN
4 Play from
Bluetooth
devices
you can listen to audio from
Bluetooth-ena bled devices.
Note
The speaker can memorize a maximum of eight paired
devices.The ninthpaired device will replace the first one.
Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
Keep away from any other electronic device that may
cause interference.
The operational range between this speaker and a
Bluetooth device is approximately 20 meters (66 feet).
Connect a device
1To turn the speaker on
» The LED indicator
2
On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
that can be paired (refer to the user
manual of the device).
3Select [Philips S2505] displayed on your
device for pairing and connection. If
necessary, input “0000” as the pairing
password.
» After successful pairing and connection,
the speaker beeps twice, and the LED
indicator turns solid blue.
If you cannot find
[Philips S2505] on
your device, press and hold PAIRING
for more than three seconds until you
hear triple beeps.
4Play Bluetooth device.
Tip
· You can use your Bluetooth device to control play.
LED indicator (blue)
Indicator Bluetooth connection status
Fast blinking (2Hz) Pairing
Slow blinking (1Hz) Connecting
Solid blue Connected
Disconnect a device
Press and hold PAIRING for more than
five seconds;
» The speaker beeps for three times.
Disable Bluetooth on your device; or
Move the device beyond the
communication range.
» The speaker beeps twice, and the LED
indicator blinks blue.
Note
Before connecting another Bluetooth device, disconnect
the
current device first.
With this speaker,
blinks blue.

6EN
Reconnect a device
When you turn on the speaker, it will reconnect
the last connected device automatically; If not,
select [Philips S2505] on your Bluetooth device
to start connection.
Bluetooth Profile

3W RMS
0.19
1
120Hz - 18kHz
80
1.75"
91.5 x 91 x 41mm
850
V5.0
A2DP V1.3, HFP V1.7
AVRCP V1.6
2402-2480 MHz
20
Bluetooth Profile
Operation Ambient
IP protection class
0č~40č
IPX7

Philips S2505

MMD Hong Kong Holding Limited may void the
user's authority to operate the equipment.
Hereby, MMD Hong Kong Holding Limited
declares that this product is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC. You can find
the Declaration of Conformity on
www.philips.com/support.
MMD Hong
Kong Holding Limited is under license. Other
trademarks and trade names are those of their
respective owners.
The Bluetooth ®word mark and logos are
registered trademarks owned by the Bluetooth
SIG, Inc. and any use of such marks by
Disposal of a battery into fire or a hot oven, or
mechanically crushing or cutting of a battery, that
can result in an explosion.