
2EN
1 Safety and 
Notice
Read and understand all instructions before you 
use this product. If damage is caused by failure 
to follow the instructions, the warranty does 
not apply.
Safety
Warning
•Never remove the casing of this apparatus. 
•Never lubricate any part of this apparatus.
•Never place this apparatus on other electrical 
equipment.
•Keep this apparatus away from direct sunlight, naked 
amesorheat.
•Never look into the laser beam inside this apparatus.
•Ensure that you always have easy access to the power 
cord, plug or adaptor to disconnect this apparatus from 
the power.
a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings. 
Install in accordance with the 
manufacturer’s instructions.
h Do not install near any heat sources such 
as radiators, heat registers, stoves, or 
other apparatus (including ampliers) that 
produce heat. 
i Protect the power cord from being 
walked on or pinched, particularly at 
plugs, convenience receptacles, and the 
point where they exit from the apparatus.
j Only use attachments/accessories 
specied by the manufacturer.
k Use only with the cart, stand, tripod, 
bracket, or table specied by the 
manufacturer or sold with the apparatus. 
When a cart is used, use caution when 
moving the cart/apparatus combination to 
avoid injury from tip-over. 
 
l Unplug this apparatus during lightning 
storms or when unused for long periods 
of time. 
m Refer all servicing to qualied service 
personnel. Servicing is required when 
the apparatus has been damaged in any 
way, such as power-supply cord or plug 
is damaged, liquid has been spilled or 
objects have fallen into the apparatus, the 
apparatus has been exposed to rain or 
moisture, does not operate normally, or 
has been dropped.
n Apparatus shall not be exposed to 
dripping or splashing. 
o Do not place any sources of danger on 
the apparatus (e.g. liquid lled objects, 
lighted candles). 
p Where the MAINS plug or an appliance 
coupler is used as the disconnect device, 
the disconnect device shall remain readily 
operable.
q Make sure there is enough free space 
around the product for ventilation.
r Batteries (battery pack or batteries 
installed) shall not be exposed to 
excessive heat such as sunshine, re or 
the like.