Philips 9290 014 60962 User manual

Wireless Wall Touch Panel
Wireless Wall Touch Panel
Wireless
9290 014 60962
1. Communication distance: 15-30M
Installation guide
1. Put the power supply of accessories into 86 boxes and connect the 220V mains wire with the wire L and N of the accessories;
(where input: brown L, blue N; Output: 2 pin jack, red L, black N; Note: please disconnect the 220V power supply when wiring.
2. Fix the base of product to the 86 base of wall with screws;
3. Connect the output of the accessory power supply and the power input of the multi-function touch panel as shown below;
4. Gently press touch switch which is on the wall to the base.
1. ① Mains input 1. ①/②/③ button for group
2. ② Toggle switch
3. Socket for factory③
2. ④ Switch of on/off
3. ⑤/⑥ Button for dimming
For detailed information of APP , please refer to ：
www.beesmart.com.hk:88
12 NC
9290 014 60962
The information provided herein is subject to change, without notice. Signify does not give any representation or warranty
as to the accuracy or completeness of the information included herein and shall not be liable for any action in reliance
thereon. The information presented in this document is not intended as any commercial offer and does not form part of
any quotation or contract, unless otherwise agreed by Signify.Philips and the Philips Shield Emblem are registered trademarks
of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
www.philips.com/lighting
2018 Signify Holding, IBRS 10461, 5600VB, NL. All rights reserved.

02 Select One Option
05 Input MAC CODE
New product can be located after
successful adding
Network overtime or searching failure
warning,please check again
03 scan
06 Select Zone
01 Add Product
04 Search
07 Successful Adding 08 Adding Failure
Product configuration
Check Gateway and
compatibility
enviromnent
1
Check product power-on condition
2
Retry after few seconds
3
Turning the slide switch on the back to the up, meanwhile long press the ④ and ⑤keys, LEDs is brightening and then off, ① keys is flash,
the remote is restored to the original state.
1 . Searching and adding new equipment in APP and Gateway also open the Zigbee mesh network.
Press ①、② and ③ keys which are equipment group, and then LED under button will brighten up. ⑤、⑥ Key for dimming,
Press ④、⑤、⑥ keys to control equipment and dimming.
④ Keys for ON/OFF .
2 . Turn the slide switch downward on the back, keys is flash, which mean exit to network, if not, it's successful for accessing to network.
If can't access to network, pls restore to the original state.
①