Philips FC6687/01 User manual

Brilliance FC6688, FC6687, FC6686, FC6685

ENGLISH 4
ESPAÑOL 10
FC6688, 6687, 6686, 6666
3

Important
◗Read these instructions carefully and look at the illustrations
before you start using the appliance.
◗Never use the appliance on wet floors, or floors on which ashes or
inflammable or explosive liquids are present.
◗Make sure that the handstick is in upright position (i.e. that the
appliance is switched off) before connecting it to the mains.
◗Always remove the mains plug from the wall socket before turning
the polisher upside down, e.g. to remove or attach the brushes or
polishing discs.
◗Make sure that the mains cord does not end up under the
appliance while it is running. Prevent hands, feet, hair, clothes, etc.
from coming into contact with the rotating brushes or discs.
◗If the mains cord of this appliance is damaged, it must always be
replaced by Philips or a service centre authorised by Philips, as
special tools and/or parts are required.
Preparing the appliance for use
C1Connect the upper part of the handstick to the handle by
means of the screws provided.
C2Connect the upper part of the handstick to the lower part of
the handstick by means of the screws provided.
C3Place the handstick in the base of the appliance. Use the screws
provided to secure the connections.
ENGLISH4
1
2
2
1
2
2
2
2
1

C4Slide the top of the dustbag in the upper dustbag holder.
C5Connect the bottom of the dustbag to the appliance.
C6Remove the two metal clamps by turning one of the rubber
wheels with your hand. Do not put the clamps back between
the wheels.
C7Attach the brushes or the polishing discs.You will hear a click
when you attach them properly.
C8To detach the brushes or polishing discs, simply pull them off
the appliance.
Before polishing
1Clean the floor with a vacuum cleaner.
2Remove stains, etc.
ENGLISH 5

Polishing
C1Unwind the mains cord and put the mains plug in the wall
socket.
C2For extra safety: wind the cord around the handle once and put
it in the cord holder.
C3To switch the appliance on, push the handstick down and pull it
towards you.
C4After having rubbed the floor polish onto the floor, wait until
the polish has dried and use the brushes to polish the floor
C5Always move the appliance in straight lanes. Circular
movements will produce less good results.
ENGLISH6
12

C◗To give wooden floors (e.g. parquet) a deep shine, use the felt
polishing discs.
C◗Type FC 6688 only: select 'shining/***' for extra and long-lasting
shine.
C◗To wheel the appliance across the floor without polishing, put the
handstick in vertical position and tilt the appliance backwards.
Storing the appliance
C1Wind the mains cord around the storage hooks.
C2Fasten the end of the cord.
◗The appliance can be stored with the brushes or discs still
attached. It is not necessary to detach them.
ENGLISH 7

Emptying the dustbag
C1Empty the dustbag from time to time. First detach the lower
part of the dustbag.
C2Pull the upper part of the dustbag out of the holder.
C3Turn the dustbag upside down over a dustbin and carefully
shake the dust out of it.
Do not forget to reattach the dustbag before using the polisher again.
The dustbag can be washed with ordinary detergents.
Cleaning
1Remove the mains plug from the wall socket before cleaning
the appliance.
2Use a damp cloth to clean the appliance.
Never immerse the appliance in water.
3Detach the brushes and clean them with water and some
detergent.
4Clean the felt polishing discs by brushing them in soapy water.
Then wipe the discs with a damp cloth.
5Let the brushes and discs dry in horizontal position.
ENGLISH8

Information & service
If you need information or if you have a problem, please visit the Philips
Web site at www.philips.com or contact the Philips Customer
Care Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and Personal Care BV.
ENGLISH 9

Importante
◗Lea estas instrucciones de uso atentamente, observando al mismo
tiempo las ilustraciones, antes de utilizar por primera vez el
aparato.
◗Nunca emplee el aparato en pisos húmedos, cenizas, líquidos
inflamables o explosivos.
◗Antes de conectarlo a la red, asegure que el mango está en
posición vertical (significa aparato apagado)
◗Saque siempre la clavija del tomacorriente antes de voltear la
lustradora, por ejemplo, para cambiar cepillos o fieltros
◗Asegure, que la lustradora no pase encima del cable de
alimentación. Evite el contacto de manos, pies, cabellos, prendas de
ropa, etc., con las escobillas o los fieltros, cuando el aparato esté
en operación.
◗Si el cable está dañado, debe recurrir a un taller de servicio
autorizado Philips para su reparación, (se requieren herramientas/
partes especiales para su reparación).
ARMANDO LA LUSTRADORA
C1Monte el mango al tubo, utilizando los tornillos provistos en la
caja
C2Utilizando los tornillos que se suministran, conecten la parte
superior del mango a su parte inferior.
C3Coloquen el mango en la base del aparato.Para asegurar las
conexiones, utilicen los tornillos que se suministran.
ESPAÑOL10
1
2
2
1
2
2
2
2
1