Philips FC8209/01 User manual

ServiceManual
Philips Consumer Lifestyle
Published by Philips Consumer Lifestyle Printed in the Netherlands © Copyright reserved Subject to modification
Vacuum cleaner
FC8209/01
08/08
PRODUCT INFORMATION
- This product meets the requirements regarding
interference suppression on radio and TV.
- After the product has been repaired, it should function
properly and has to meet the safety requirements as
officially laid down at this moment.
TECHNICAL INFORMATION
- Colour : Marine Blue
- Power consumption : 1400 W
(IEC) 230V
- Maximum Air displacement : 32 l/s
- Dust storage capacity : 2 L
- Cord length : 6 m
(depending on type)
- Filter system : Double layer S-bagTM
: Permanent motor
protection filter
: AFS exhaust filter
- Noise : 85 dB
ACCESSORIES
- Nozzle : All purpose floor nozzle
- Tubes : Telescopic tube with extension piece
- Accessories : Crevice nozzle, small nozzle
- Coupling : Conical coupling
OPTIONAL (accessories)
- FC8021 Synthetic S-Bag 8838 021 03010
- FC8022 Clinic S-Bag 8838 022 03010
- FC8023 Anti Odour S-Bag 8838 023 03010
= changed

FC8209/01
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- First remove the dust bag.
- Remove the dustcover using a screwdriver (see picture).
- When the dustcover has been removed, the 5 screws Athat
need to be unscrewed to disassemble the upper housing, are
accessible.
A
A
A
A
A
- After removing screw B, lift the motor cap (item 14) out of
the lower housing to be able to take out the cord winder
unit.
B
- To disassemble the cord winder, use TORX screwdriver
no. T10, which is one of a set consisting of T20; T15; T10;
T9; T8; T7 and T6 (code number 4822 395 50145).
- During re-assembling, take care the wires are positioned in
the guides correctly.
REPAIR INSTRUCTION
- The spare parts have been standardized as much as possible.
- Depending on the original cord, the spare cord must be
shortened to the length of the original cord.
- The cord winder spring must be tensioned to the maximum
level and then be rewound approx. 1.5 turn
- If the reel half spring unit is replaced, shaft Dmust be
lubricated with silicone grease. Do not apply any silicone
grease to or spill any grease on terminals (item 27) or
conductors (item 26).
- When the vacuum cleaner is used to suck up fine dust, the
pores of the dustbag may become clogged, causing the
passage of air through the dustbag to become obstructed.
As a result, the dustbag-full indicator will indicate that the
dustbag needs to be replaced, even though the dustbag is
not full at all.
ELECTRICAL DIAGRAM
M
MAIN
SWITCH
CORD WINDER
C
2-6

FC8209/01
PARTS LIST
3-6
Pos Service code Description
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
15a
16
17
18
19
20
4322 009 09690
4322 005 20800
4322 003 28510
4322 001 73610
4322 000 38890
4322 003 28600
4322 003 28480
4322 005 20760
4322 003 28590
4322 000 68060
4322 003 28570
4322 003 29580
4322 006 23390
4322 006 23460
4322 003 28560
4322 000 38900
4322 003 28660
4322 003 29110
4322 001 73600
4322 005 22630
4322 001 73590
4322 003 28680
Dustcover Assy Marine blue
Dustbag carrier assy
Side panel
Dustcover seal
Inlet filter Gemini
Inlet grille Pearl blue
Nose piece
Caster assy
Buttons Artic Ice
Button spring
Back panel Dark raven
Switch cap non-electronic
PCB non electronic
PCB non electronic 127 V
Motor cap
AFS Filter Gemini
AFS filter frame
Air outlet cover AFS
Plug Gemini Bag
Lower housing non electronics
Motor buffer front
Motor front support Domus
Pos Service code Description
21
22
23
24
25
26
27
28
29
30
31
32
33
34
36
37
38
39
40
41
42
4322 006 98040
4322 006 97970
4322 006 98000
4322 003 28550
4322 001 73580
4322 005 20770
4322 009 07610
4322 009 09060
4341 005 01330
4341 005 00790
4341 006 01890
4322 006 02160
4322 006 02060
4322 006 02080
4322 006 07600
4341 004 20420
4341 005 01240
4341 004 20170
4322 004 23520
4822 479 20039
4822 479 20038
4341 004 20100
4322 004 23740
4322 004 23490
Motor Domus 240 V 1400 W
Motor Domus 230 V 1400 W
Motor Domus 220 V 1400 W (ccc)
Air guide Domus
Bufferback Gemini
Base plate assy Gemini
Real half spring unit
Real half spring unit PRC
Real half contact side
Contact plate assy
Cordset Taiwan/PRC L = 5.3 m
Cordset U.K./H.K. L = 6.3 m
Cordset Europe L = 6.3 m
Cordset Swiss L = 6.3 m
Cordset Brazil L = 7.3 m
Bend/hose assy
Bend handle
Crevice nozzle con.
Nozzle D272
Nozzle brush
Nozzle strip
Small Nozzle con.
Extension tube
Telescopic tube
* Standardized colour
= changed

FC8209/01
EXPLODED VIEW
1
9
10
11
14
15a
15
16
12
13
17
3
5
6
4
7
2
8
18
4-6

FC8209/01
EXPLODED VIEW
2322212019
25
27
28÷32
26
D
C
C
24
5-6

FC8209/01
EXPLODED VIEW
Taiwan / P.R.C. 28 Korea / Europe 30
Swiss 31
Brazil 32
29
H.K. / U.K.
37
38
39
33
34
36
40
42
41
6-6