Philips Impact Plus FC8388 User manual

Impact Plus
FC8388 / FC8386 / FC8384 / FC8382

2

3
21
11
10
6
2
5
10
14
2424
20
4
3
99
1
23
16 17
8
13
19
12
22
26
15
25 27
7
18

4

ENGLISH 6
13
FC8388, FC8386, FC8384, FC8382
5

Important
◗Only use Philips double-layer paper dustbags Sydney+ or S-bag`
or the cotton dustbag provided (types FC8388, FC8386, FC8384
only).
◗Never suck up water or any other liquid. Never suck up ashes until
they are cold.
◗When the vacuum cleaner is used to suck up fine dust, the pores
of the dustbag may become clogged, causing the passage of air
through the dustbag to become obstructed.As a result, the
'dustbag full' indicator will indicate that the dustbag needs to be
replaced, even though the dustbag is not full at all.
◗Never use the appliance without the Motor Protection Filter.This
could damage the motor and shorten the life of the appliance.
◗If the mains cord of this appliance is damaged, it may only be
replaced by Philips or a service centre authorised by Philips, as
repair requires special tools and/or parts.
General description
1On/Off button
2Cordwinder button
3Opening dustcover
4Dustbag
5Hinging handle
6Opening filtercover
7Tapturn opening
8Front grip
9Dustbag full indicator
10 Turnknob
11 Rearwheels
12 Front wheel
13 Storage position
14 Small nozzle (types FC8388, FC 8386 only)
15 Crevice tool
16 Plastic tubes (type FC8382 only)
17 Chrome tubes (types FC8386, FC8384 only)
18 Telescopic tube (type FC8388 only)
19 Parking ridge
20 Plug
21 Motor protection filter assy
22 Typeplate
23 Bend with hose assy
24 Twist & Clean nozzle (type FC8388 only)
25 Twist & Clean polishing pads (type FC8388 only)
26 Combi nozzle
27 Cotton dustbag (types FC8388, FC8386, FC8384 only)
ENGLISH6

Connecting accessories
C1To connect the hose, push it into the appliance and turn it
clockwise.
To disconnect the hose, turn it anticlockwise and pull it out of the
appliance.
C2Connect the tubes to each other and to the handgrip by
inserting the narrow section into the wider section while
turning it a little.The tube with the clip is the lower tube.
You can connect the accessories in the same way.
Disconnect the accessories and tubes by pulling them and turning them
a little.
C3Telescopic tube (type FC8388 only):
Adjust the tube to the length you find most comfortable during
vacuum cleaning.
4The combi nozzle can be used on either carpets (without
brush) or hard floors (with brush):
C◗Push the rocker switch on top of the combi nozzle with your foot
to make the brush strip for cleaning hard floors come out of the
nozzle housing.
C◗Push the rocker switch on the other side to make the brush strip
disappear into the housing.
ENGLISH 7

C5The crevice nozzle can be found in the special storage
compartment.
Vacuum cleaning
C1Pull the cord out of the appliance and put the mains plug in the
wall socket.
Switch the appliance on by pushing the on/off button.
C2To carry the appliance, put the handle in upright position.
C3You can adjust the suction power by means of the slide on the
handgrip.
C4You can adjust the suction power by means of the electronic
suction power control .
ENGLISH8

Storage
C1Switch the appliance off and remove the mains plug from the
wall socket.
Rewind the mains cord by pressing the cord rewind button.
C2Put the appliance in upright position and attach the lower tube
to the appliance by means of the clip.
The clip can be slide along the tube to adjust its height.
Replacing the dustbag
◗Replace the dustbag as soon as the 'dustbag full' indicator has
changed colour permanently.
C1Switch the appliance off and open the cover.
C2Push the dustbag holder backwards.
C3Lift the dustbag out of the compartment by pulling the
cardboard lug upwards, which causes the dustbag to be sealed.
ENGLISH 9

C4Slide the cardboard front of the new dustbag into the two
grooves of the dustbag holder. Press it down as far as possible.
C5Pull the dustbag holder forwards ('Click').You cannot close the
cover if no dustbag has been inserted.
Philips double layer dustbags Sydney+ are available under type number
HR6999.
Philips S-bag`paper dustbags are available under type number
FC8021.
◗If provided, you can use the cotton dustbag instead of paper
dustbags.
The cotton dustbag can be used and emptied repeatedly.
For removing and inserting the cotton dustbag, simply follow the
instructions for replacing paper dustbags.
To empty the cotton dustbag:
1Remove the clip by sliding it off the dustbag sideways.
2Undo the metal hooks.
3Shake out the contents.
4Close the dustbag by fastening the metal hooks and sliding the
clip back onto the bottom edge of the dustbag.
Filter replacement
AFS Micro Filter
Replace the AFS Micro Filter when you insert the first of a new set of
dustbags or once a year if you are using a cotton dustbag.
The AFS Micro Filter will remove a large part of the smallest particles
from the exhaust air.
C1Open the grill and remove the filter
ENGLISH10