Phoenix Gold Z5CS User manual

Z5CS Z65CS
Component Speakers
Z

PHOENIX GOLD
COMPONENT SPEAKER SYSTEMS
SPECIFICATION Z5CS Z65CS
Peak Power (watts) 140 Watts 160 Watts
Rated Power (watts) 35 Watts 40 Watts
Frequency Response 41Hz-26KHz 35Hz-26KHz
Impedance 4 Ohm 4 Ohm
Sensitivity 85dB 86dB
Cone Material Polypropylene Polypropylene
Tweeter PEI PEI
Mounting Depth 45mm (1-13/16”) 46mm (1-13/16”)
Mounting Diameter 118mm (4-5/8”) 126mm (5”)
53
2-1/16"
9
3/8"
47
1-13/16"
20 13/16"
p Component Fixing
t Tweeter Dimensions
INSTALLATION GUIDELINES
Ensure the audio system is turned o before making any connections to the amplier, speakers
or source unit. Failure to do so could result in permanent damage to the audio system.
When wiring the speakers ensure that the wire is protected from sharp objects and always use
rubber grommets when wiring through metal panels. Ensure all terminals and connections are
protected from the vehicle chassis and from each other as failure to do so could result in
permanent damage to the audio system.
When connecting speakers to the source unit or amplier ensure you connect the positive and
negative output wire from the source unit to the corresponding speaker terminals. This will
ensure the audio system will be in phase.
1. Ensure there is adequate clearance and depth for the speaker to be mounted.
2. Use the supplied template to mark out & cut the correct diameter hole.
3. Drill four holes for the mounting screws.
4. Separate the grille from the frame
5. Insert the speaker and grille and ax with the screws provided
6. Complete installation by replacing the grille into the grille frame.
53mm (2-1/16”)
47mm (13/16”) u
u
u
u
u
u
u
u
9mm (3/8”)
20mm (13/16”)

WARNING
Do not drill mounting holes with speaker in place as this could allow drill shavings to damage
the voice coil and void the speaker warranty.
TWEETER (Surface/Angle Mount)
To obtain the best performance from the tweeter it should be located on axis to approximately
4” below the rear view mirror. Select the mount you require and use this as a template to drill
the holes to mount or alternatively if using an adhesive pad ensure the mounting surface is
cleaned with a residue free cleaner and attach the speaker using the adhesive pad. Attach
the wires to the speaker terminals.
TWEETER (Flush Mount)
Ensure you have adequate depth to mount the tweeter and cut a 50mm hole. Assemble
the rear mount with the spring clamp and press through from the rear of the hole, then
attach the front plate to the rear plate. Attach the wires to the speaker terminals.
CONTENTS
2 x PHOENIX GOLD COMPONENT SPEAKERS
2 x PHOENIX GOLD TWEETERS WITH WIRES
2 x PHOENIX GOLD SPEAKER GRILLES
1 x TWEETER MOUNTING HARDWARE
1 x MOUNTING TEMPLATE
8 x MOUNTING SCREWS
1 x USER MANUAL
NOTE
SPEAKER WIRE INCLUDED WITH THE
COMPONENT SPEAKER SYSTEM WILL
ONLY CONNECT THE TWEETER TO THE
SPEAKER, ADDITIONAL SPEAKER WIRING
IS NEEDED TO CONNECT TO THE AUDIO
SYSTEM.
WARNING:
Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB
may cause permanent hearing loss. Please watch for emergency vehicles as warning signals may not be heard.

Designed and Engineered in the UK
Made in China
Phoenix Gold
A Division of AAMP of America
15500 Lightwave Drive,
Suite 202, Clearwater, FL33760
[email protected]
www.phoenixgold.com