Phoenix Hydro-X Caddy User manual

Caddy Kit Instructions
TS-380 11/06
Phoenix Hydro-X Caddy Instructions
Attach Hydro-X Caddy to the floor of your vehicle
with hardware supplied. Make sure the cut out
for the wheels is facing the accessible side of
the vehicle.
1
Next, roll the Hydro-X on to the caddy, placing the wheels in the notch.
2
Using the (2) long 36” bungee straps provided, attach to one of the holes on the front of
the Caddy (opposite the wheels) and hook the top end onto the hose arm. Repeat on the
opposite hole and arm for the second strap. The bungees should be crossed for added
stability.
3
1 - 4026738 Tie Down, 26” Red
2 - 4025703 Tie Down, 36” Red
1 - 4025692 Carrier Assy, Phoenix Hydro-X
1 - Instruction Sheet
KIT INCLUDES:
4 - 1207352 1/4-20 SS Nut
4 - 1209386 1/4 Lock Washer
4 - 1208386 1/4 Flat Washer
4 - 1091008 1/4-20 x 3/4 Hexhead Bolt

Using the shorter 26” strap, wrap the back of the base of the Xtreme Xtractor as
illustrated below:
5
If transporting the Hydro-X Xtreme Xtractor without the Vac Pac, the following illustrates
the placement of the bungee cords.
NOTICE: The longer straps are used for this, and have to be
wrapped once around the stem. The short strap is
not used in this scenario.
P.O. Box 8680
Madison, WI 53708
800-533-7533
FAX: [phone]
Information in this document is subject to change without notice. No part of
this document may be reproduced or transmitted in any form or by means,
electronic or mechanical, for any purpose without the express written permission
of Therma-Stor.