Phonema PHITS I38 User manual

PHITS I38 - Assembly manual
1. Remove both the metal cover and the front
panel.
2. Cut the plastic clamp that holds the cable.
3. Separate the speaker enclosure from the front
panel by removing the four screws that hold it.
4. Separate the speaker enclosure by removing
the rear Allen screw.
5. Cut the cable as close as possible to the speaker so that it remains
as long as possible.
6. On the front panel, place the gasket with the white side facing in and
screw the new speaker using the four screws.

*Some models may vary from this manual.
7. Place plates B and BK.
8. Sold the cables again
respecting polarity (The cable
marked with a long dash line is
the negative pole).
9. Fix the front panel with the
two screws.
10. Place plates L and R so that
they fit between plate B and
the metal wall of the base.
11. Place the Basotect cube and the T plate so that they fit with the BK, L
and R plates.
12. Replace the metal cover and fix it with
the screws.
Enjoy your new sound!