Pink Diamond Wax Warmer Kit User manual

1-Year Manufacturer Warranty
Please note: The warranty is ONLY valid AFTER
your registration.
User Manual
Hey beautiful! Please don’t start in a hurry.
Read this before starting your journey to silky-smooth.
CONTACT US
We are always ready to help if you have any concerns
with the purchase.

-1-
Removable
aluminum pot
Heat resistant
ABS
Temperature
control
Power plug
Indicator light
Lid
INTRODUCTION
Congratulations on the purchase of this Waxing Kit. You have selected a high-quality
product. Please familiarize yourself with all operating and safety instructions BEFORE
using this appliance.
INTENDED USE
This appliance has been designed exclusively for hair removal of legs, armpits and the bikini
zone on the human body. The warmer is suitable for use for all wax types (including canned
wax). It is intended solely for use in private households.
TECHNICAL DETAILS
Voltage
Power consumption
Capacity
110 - 240 V ~ (AC), 50 - 60 Hz
50 W
500 ml

-2-
This product has been tested to comply with EMC Directive (2014/30/EU),
LVD Directive (2014/35/EU), and FCC standards.
* During the first few minutes of initial use, you may notice a slight odor. This is normal and
will quickly disappear.
!
WARNING:
Please note that hair removal (of any kind!) can cause trauma to the skin, and
normal skin reactions may occur such as redness, swelling, tenderness, etc.
► Before waxing, do a 24-hour patch test to see how skin reacts.
► Beware of burns. Wax can reach high temperature and cause burn injuries!
► Do not wax the area with redness, inflammation, swelling, open wounds, burns, eczema
or psoriasis.
► Please consult with your doctor before use if you are susceptible to allergic reactions or
have any health concerns.
When using electrical appliances, especially when children are present, basic safety
precautions should always be followed including:
READ ALL INSTRUCTIONS BEFORE USING.
DANGER – To reduce the risk of ELECTROCUTION:
1. Always unplug this appliance immediately after using it.
2. Connect this appliance to a properly grounded outlet only.
3. Do not use while bathing or showering.
4. Do not place or store appliance where it may fall or be pulled into a tub or sink.
5. Do not immerse the appliance in water or other liquids!
6. NEVER reach in to get an appliance that has fallen into water. Make sure you don’t stand
in water and unplug immediately with electrically insulated gloves.
C
IMPORTANT SAFETY INSTRUCTIONS

-3-
WARNING!
RISK OF ELECTROCUTION!
NEVER use this appliance near a bath
tub, shower or other vessels filled
with water.
CAUTION – To reduce the risk of fire, burns, electric shock or any
other injury:
1. This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or reasoning capabilities, or lack of experience and knowledge,
provided that they are under supervision or have been told by a responsible person regarding
use of the appliance in a safe way and understand the potential risks involved.
2. Always test before use: apply hot wax on a small area of the skin for warmth and possible
skin reactions.
3. Use this appliance on a level, heat-resistant surface.
4. Do not leave the appliance unattended while it is being operated or plugged in.
5. Use this appliance only for its intended use. The use of attachments not recommended by
the manufacturer may cause hazards.
6. Do not allow children to play with the appliance.
7. Close supervision is necessary when this appliance is used near children or invalids.
8. Unplug from outlet when not in use. Allow cooling before handling, cleaning or storing
the appliance.
9. Never operate this appliance if it has a damaged cord or plug, if it is not working properly,
if it has been dropped or damaged in any manner or dropped into water.
10. Keep the cord away from hot or heated surfaces. Do not wrap the cord around the
appliance.
11. Do not drape the cord over a counter or a tabletop in such a manner that it can be pulled
on by a child or tripped over unintentionally
12. The use of an extension cord is not recommended.

-4-
You'll see the indicator light turn from red to off when the desired temperature is reached.
* The temperature will remain constant, meaning the warmer will automatically turn on to
heat wax when it drops below the desired temperature.
HOW TO USE THE WAX WARMER
1. Fill the removable pot with 3.5-11 oz wax beads.
2. Place the pot into the designated insert within the warmer.
3. To melt wax quickly, place the lid on and turn the dial clockwise to max heat.
4. After the wax is melted into a liquid consistency, adjust to your desired temperature.
150
149 F
196 F
1. READY
Hair should be 1/4 inch long to wax effectively. Your skin should
be clean and dry.
2. SET
Put wax into the wax warmer and allow the beads to melt until it's
the consistency of honey.
3. TEST
Test a small amount of melted wax on the inside of your wrist to
make sure that it's not too hot.
4. APPLY
Using the applicator, apply the wax in the direction of hair growth.
Work in small manageable sections.
5. COOL
Wait for 30-45 seconds and allow the wax to harden. It's ready to
remove as soon as it's no longer sticky to the touch.
6. PULL
Hold skin taut. Flick the edge of the wax-up and pull quickly in
the opposite direction of hair growth.
QUICK-START GUIDE
USER INSTRUCTIONS

-5-
The left-over wax can be melted and reused for application next time.
To clean your pot, please ensure that the appliance is unplugged but still warm.
Use cotton muslin strips or paper towels to wipe clean. You can also use a wax
warmer cleaning solution or a small amount of oil.
PRO TIPS
To achieve a more effective hair removal result, we strongly recommend you
to:
► Apply wax in direction with hair growth and remove in opposite.
► Hydrate and exfoliate a day or two prior to waxing.
► On the day of waxing, avoid using any lotions or creams.
► When removing, pull the wax parallel and close to your waxed skin.
► Avoid undue sun exposure for 24-48 hours.
► Exfoliate after at least 24 hours to help prevent ingrown hairs.
► Get on a regular waxing schedule and avoid shaving in between waxing.
HOW TO USE THE WAX BEANS
Application of hard wax depends on the area to be waxed and how coarse the hair is.
To perform an effective result, it's recommended that you follow
the instructions below:
1. Allow the wax to melt completely. We recommend a temp between 150-180℉.
2. The best indication that your wax is the right applicable temperature is when it resembles
the consistency of thick honey.
3. Always use with caution. It’s important to test a small amount of melted wax on the inside
of your wrist before application.
4. Make sure your skin is completely dry before waxing. Apply some baby powder to soak
up any excess moisture if necessary.
5. Using the applicator, apply wax in direction of hair growth. Use firm pressure to ensure
each hair is shrink-wrapped with wax.
6. Wait 30-45 seconds and allow the wax to harden.
7. It's ready to be removed as soon as it's no longer sticky to the touch. Hold skin taut. Flick
the edge of the wax up and pull quickly AGAINST direction of hair growth.
8. Repeat over different sections until the desired area is soft, silky hair-free.
READ ALL INSTRUCTIONS BEFORE USING.
EASY CLEANUP OF WAX POT
Note: You don’t need to clean the wax pot after each use!

-6-
APPLICATION
Apply wax following
direction of hair growth
Remove AGAINST the
hair growth
* Please treat only small areas at once if you are new to waxing.
EYEBROWS
-Brush, shape, and cut brows before waxing.
-Use the mini brow applicator and wax in small sections for precise results.
-Use Vaseline or coconut oil as a protective barrier over any brow hair you don't want the
wax to stick to.
-Be cautious that wax doesn't drip into eyes.
UPPER LIP, CHIN & CHEEKS
-Wax your upper lip in three sections: right, left, and center.
-Facial hair can grow in swirls, so stick with small sections.
UNDERARMS/LEGS
-Note the hair growth pattern before you begin. You may need to wax in several sections if
your armpit hair grows in multiple directions.
-Applying against hair growth may be necessary to completely pick up all the hair.
LOCATION
BIKINI & BRAZILIAN
-Have a mirror on hand.
-Sit on the floor or on your bed with a towel under you, with the soles of your feet
touching each other.
-Start waxing from the outside edges of the hairline, where your hair is thinnest and less
sensitive.
-Take note of the way your hair grows. Work in small manageable sections.
-Hold your skin taut while removing wax, especially in sensitive areas prone to bruising.

-7-
Do I need cloth strips?
Nope. No cloth strips are needed with hard wax.
Is that normal If the wax warmer auto turns on and off?
This wax warmer has AUTOMATIC POWER OFF FUNCTION -- When wax warmer in a
hot temperature, indicator light will turn down automatically and turn on when temperature
is low.
Why didn't the wax remove all my hair?
-The hair was too short. The ideal length for wax to grip and remove hair from root is
0.25inch-0.75inch (0.6cm-2cm).
-The wax was too cool. Heat the wax until it's the consistency of honey.
-Sometimes hair grows in multiple directions. Try a second application while applying the
wax in an alternate direction.
-If hair remains after 2-3 passes, it's best to clean up with tweezers.
-Apply more pressure with the applicator. Firm pressure ensures each hair is shrink-wrapped
with wax.
Why is wax residue left on my skin?
-The wax was applied too thin. Use a little more. Apply it about a nickel thick.
-The wax was applied unevenly. With practice you will avoid this issue.
-Use the AFTER-Wax treatment oil to remove any residue.
How long should my hair growth be?
We advise waiting until your hair is at least ¼ inch in length (around the size of a grain of
rice). If your hair is too short, there won’t be enough length for the wax to grip it, and your
results won’t be successful.
Are there any concerns I should be aware of?
-Avoid applying wax to moles, warts, mucous tissue, sunburned or irritated skin.
-Do not use wax if you’re taking Retin-A or Accutane.
-Do not wax after plastic surgery or a chemical peel until approved by a physician.
-Avoid sun and hot water for 8 hours after use.
TROUBLESHOOTING Q+A

-8-
Your product will either be repaired or replaced if any defect in material or workmanship
occurs within ONE year from the date of purchase. The repair or replacement of a product
does not signify the beginning of a new warranty period.
Please note this warranty does not apply if:
1. The product has been damaged by accident, abuse or mishandling.
2. The product has been used in a way that does NOT follow the Wax Warmer
User Manual.
3. Units subjected to unauthorized repair.
Manufacturer:
ZHONGSHAN CITY PINK DIAMOND COSMETICS TECHNOLOGY CO., LTD.
U.S. FDA Establishment ID: 1009665
Address: Building 11, No.11, Gangbao Road
Tongmao Industrial West Avenue, Dongsheng Town
Zhongshan City, Guangdong Province, P. R. China
Email: [email protected]
Authorized Representative
* Please note that the following address is not the service address.
Disposal
Please DO NOT dispose of the appliance in your normal domestic
waste. This product is subject to the provisions of the WEEE
Directive (2012/19/EU). Disposal can take place through an
approved disposal center at your community.
Please contact your local community or municipal authorities if you
have any doubt about how to dispose of the worn-out product.
The environmentally friendly packaging can be easily disposed of at
any of your local recycling facility.
1-YEAR MANUFACTURER WARRANTY
Table of contents